SECO-LARM SD-969-A18Q User manual

®
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for one (1) year from the date of sale to the original customer.
SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused by
or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM
determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM and the purchaser’s exclusive
remedy, shall be limited to the replacement or repair only, at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or
property damage of any kind to the purchaser or anyone else.
Armored Door Cords
Installation Manual
SD-969-T15Q/S shown
Also Available from SECO-LARM®:
Door Strikes Push-to-Exit Bars
SD-995C Shown SD-961A-36 Shown
Maglocks Deadbolts
E-941SA-600 Shown SD-997B-GBQ Shown
Armored Door Cord with Plastic End Caps, Silver
SD-969-A18Q
Plastic end caps
Designed to carry wiring to conduct power to
electric locks or access systems mounted in doors
Mounting screws included
Surface-mount
Inside door-cord diameter: 5/16" (8mm)
Outside door-cord diameter: 7/16" (11mm)
Armored Door Cord with Die-Cast Aluminum End Caps, Silver
SD-969-S18Q
Die-cast aluminum end caps
Designed to carry wiring to conduct power to
electric locks or access systems mounted in doors
Mounting screws included
Surface-mount
Inside door-cord diameter: 5/16" (8mm)
Outside door-cord diameter: 1/2" (13mm)

SECO-LARM
®
U.S.A., Inc.
16842 Millikan Avenue, Irvine, CA 92606 Website: www.seco-larm.com
Phone:
(
949
)
261-2999
|
(
800
)
662-0800 Email: sales
@
seco-larm.com
A
ll trademarks are the property of SECO-LARM U.S,A., Inc. or their respective owners. The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM
reserves the right to change prices and specifications without notice. SECO-LARM is also not responsible for misprints.
Copyright © 2015 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without the written permission of SECO-LARM.
®
PITGW1
MI-SD969x1xQ-151027
Armored Door Cord with Terminal Blocks and Removable Die-Cast Aluminum End Caps
SD-969-T15Q/B – Bronze
SD-969-T15Q/S – Silver
Designed to conduct power to electric locks or
access systems
Once mounted, to access, simply remove cover.
Door cord stays in place. No need to remove
from the door. Prevents stripping of the screws
and mounting points
Surface-mounted
Terminal blocks with pre-wired cables (8
connections) for quick, easy, and secure
installation
Maximum current – 3A@30VAC/VDC
15” (39cm) Stainless steel armored cord
Inside door-cord diameter: 5/16" (8mm)
Outside door-cord diameter: 7/16" (11mm)
Security screws (included) prevent tampering
Available in bronze or silver finish
SD-969-T15Q/S shown
Note: Each terminal is wired on a one to one basis, meaning that
whatever is wired to a particular terminal number on one block will
be connected to the same terminal number on the other block.
Sample Wiring Diagram
Armored Door Cord with Removable Die-Cast Aluminum End Caps
SD-969-M15Q/B shown
SD-969-M15Q/B – Bronze
SD-969-M15Q/S – Silver
Designed to carry wiring to conduct power to
electric locks or access systems
Once mounted, to access, simply remove cover.
Door cord stays in place. No need to remove
from the door. Prevents stripping of the screws
and mounting points
Surface-mounted
15” (39cm) Stainless steel armored cord
Inside door-cord diameter:
5
/
16
" (8mm)
Outside door-cord diameter:
7
/
16
" (11mm)
Security screws (included) prevent tampering
Available in bronze or silver finish