Seville Classics UltraDurable SHE24601 User manual

Recommended Tools (Not Included)
Phillips screwdriver Power drill Stud finder
Specifications
Dimensions: 60" W x 24" D x 72" H (76" H on wheels), 1" Pole Diameter
Weight capacity Per shelf Overall
On leveling feet 800 lbs. (362.8 kg) 3200 lbs. (1451.5 kg)
On wheels 200lbs.(90.7 kg) 800 lbs. (362.8 kg)
Customer Service Information
Telephone: [phone]
Fax: [phone]
Hours: 8:30 AM – 4:30 PM (PST)
Email:[e-mail]
Homepage:www.SevilleClassics.com
MEGA SHELVING
4-Tier Commercial-Grade
Steel Wire Shelving
60" W x 24" D x 76" H
Model #: SHE24601
Thank you for choosing Seville Classics! We hope that you enjoy your
commercial-grade steel wire shelving! Please read through this guide for
parts list, assembly instructions and further contact information.
RC300320 RC300320
Mounting to Wall
Use a stud nder to locate studs when positioning shelving. Loop STRAPS (L)
around rear poles (horizontal) or rear of upper shelves (vertical). Mark the
installation points through the holes in the strap with a pencil before installing.
For safe mounting, secure wall straps to wood studs whenever possible.
Avoid water or electric lines when securing shelf to wall.
Cauon
Place heavier items on the lower shelves and lighter ones on the top.
Do not stand or climb on the shelving system. Do not drop heavy items on the
system. Do not move the system while loaded. Always check that wheels are
screwed tight before moving. Replace worn or damaged wheels immediately.
Horizontal Vercal

STEP 3.
Fit SHELF (D) over the top of the 4 poles
and over SLIP SLEEVES (E).
Repeat STEPS 2-3 for next shelf.
TIP! If necessary, lightly tap shelves into
place with a rubber mallet.
Assembly Instructions
or
STEP 1.
Screw WHEELS (F,G) into
base of bottom poles until click is
felt and heard. Or, screw LEVELING
FEET (H) into poles until flush.
Repeat for all bottom poles.
STEP 2.
Snap SLIP SLEEVES (E) around the
grooves on BOTTOM POLES (A)
for your lowest shelf.
TIP! Count the number of grooves
from the bottom of the pole to
keep the height consistent.
1
STEP 4.
Screw CONNECTORS (C) into top
of BOTTOM POLES (A).
Screw TOP POLES (B) to CONNECTORS (C).
TIP! Connectors may be pre-installed.
STEP 5.
Repeat STEPS 2-3 for remaining shelves.
Congratulations!
Enjoy your now
complete shelving unit.
2
Parts List
Please make sure you have all the parts on this list.
If you’re missing parts, contact us for replacements at
[phone] or send an email to [e-mail]
A. Boom poles (4)
(Threaded end)
B. Top poles (4)
(Plasc cap on end)
C. Connectors (4)
(May be aached to poles)
H. Leveling feet (4)
D. Shelves (4)
E. Slip sleeves (16)
F. Locking wheels (2)
G. Wheels (2)
J. Anchors (4)
K. Screws (4)
L. Straps (2)