sidhil 1310 User manual

Leg Fixture Kit – 1310/EX/FF Toilet Aid
Fitting Instructions
Introduction
Thank you for purchasing this product. These fitting instructions should be read carefully before assembly of the fixed
commode legs. Please ensure that you understand all instructions, if you have any questions concerning the operation or
maintenance of the toilet aid please contact your provider.
Contents
x4 Fixed commode legs
Risk Assessment
Before fixing the legs and fitting them to the unit, assess the positioning and any relevant safety checks.
Fitment
•If standard legs are present, remove them by unclipping the “E” clips and retain for use with the fixed leg kit.
•Once the standard legs are removed, insert fixed leg units to replace them (make sure fixture holes are facing
away from the unit)
•When all 4 legs are inserted, place the commode at the desired height and lock the legs in place using the “E”
clips that were previously removed.(It is vital that you verify the height desired as the legs will not be
adjustable once fixed to the floor).
Note orientation
of holes.
Removal of
“E” clips.

08/06/2012, rev 0
•Once the height has been selected position the unit where required. The commode can now be fixed to the
floor as the customer sees fit.
Warning
•The commode must not be used if “E” clips are not correctly inserted into the legs or are missing.
•All the legs should be at the same height
•Sidhil cannot accept responsibility for incorrect/insecure fitment to the floor.
Decontamination, Maintenance & Warranty
These instructions apply to all products apart from soft products (e.g. mattresses).
•All surfaces to be wiped down with a disposable soft cloth moistened with a mild detergent and diluted in warm
water (40°C).
•The product should be cleaned by starting with the cleanest parts of the frame and systematically moving to the
dirtiest parts. Extra care should be taken around areas where dirt and dust may gather.
•The cloth should be changed during the cleaning process if it becomes soiled.
•Rinse down with clean water to remove detergent residue.
•Wipe surfaces down with 1,000 parts per million chlorine solution (0.1%).
•Dry off with a paper towel.
•Always ensure the cleaned parts are allowed to dry before re-use.
Note: If any of the 3 stages stated above (detergent, rinse down & chlorine solution) are omitted or combined it will reduce
the effectiveness of the clean.
In cases of blood spills or other bodily fluids it is recommended that a chlorine solution of 10,000 parts per million (1%) is
used instead.
The use of neat bleach or similar surface cleaners are not recommended as damage may occur on the cleaned surfaces.
There are 2 fixture holes per leg.