806870A01
s
1 / 3
Rear Terminals
Conexión posterior
Prises arrières For Use With Frame NG
Para Usar Con Caja Base NG
Use only with Siemens certified Components.
Utilizar únicamente con componentes certificados de Siemens.
A utiliser uniquement avec les composants certifiés Siemens.
Installation Instructions / Instructivo de Instalación
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplying this device is
turned on.
Couper l'alimentation del'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puedecausar la muerte o lesiones graves. Tension dangereuse.
Danger de mort ou risque de blessures graves.
Hazardous Voltage
Will cause death or serious injury
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
Turn off and lock out all power supplying this device before
working on this device.
Replace allcovers before power supplying this device is
turned on.
Couper l'alimentation del'appareil et barrer avant de
travailler.
Remplacez touts les couverts avant que
l'approvisionnement de pouvoirsoit alimenté.
Tensión peligrosa.
Puedecausar la muerte o lesiones graves. Tension dangereuse.
Danger de mort ou risque de blessures graves.
Hazardous Voltage
Will cause death or serious injury
Desenergice totalmente antes de instalar o darle servicio.
Reemplace todas las barreras y cubiertas antes de
energizar el interruptor.
I.L. No. 806870A01
Item: SRTNF3 3VL9700-4RH31
SRTNF4 3VL9700-4RJ41
RTLNSF 3VL9700-4RG01
U.S. Cat. No. Euro Order No.
6mm
Cal. ISO 6789
SRTNF4 / 3VL9700-4RJ41
- 24 X M8 X 30mm
-4X
4 X -
-4X
-24XM8
RTLNSF / 3VL9700-4RG01
- 6 X M8 X 30mm
-6XM8
-1X
1 X -
-1X
SRTNF3 / 3VL9700-4RH31
- 18 X M8 X 30mm
-3X
3 X -
-3X
-18XM8
NOTE - These instructions do not purport to cover
all details or variations in equipment, or to provide
for every possible contingency to be met in
connection with installation, operation or
maintenance. Should further information be desired
or should particular problems arise, which are not
covered sufficiently for the purchaser’s purposes,
the matter should be referred to the local Siemens
sales office. The contents of this instruction manual
shall not become part of or modify any prior or
existing agreement, commitment or relationship.
The sales contract contains the entire obligation of
Siemens. The warranty contained in the contract
between the parties is the sole warranty of Siemens.
Any statements contained herein do not create new
warranties or modify the existing warranty.
Trademarks - Unless otherwise noted, all names
identified by ® are registered trademarks of
Siemens AG or Siemens Industry, Inc. The
remaining trademarks in this publication may be
trademarks whose use by third parties for their own
purposes could violate the rights of the owner.
