Silvercrest SPBW 3000 A1 User manual

POWER BANK SPBW 3000 A1
IAN 285323
DESIGN-POWERBANK
Bedienungsanleitung
POWER BANK
Operating instructions
ВЪНШНА БАТЕРИЯ
Ръководство за експлоатация
POWERBANK
Instrucţiuni de utilizare
EKSTERNA BATERIJA
Upute za upotrebu
ΦΟΡΗΤΟΣ ΦΟΡΤΙ-
ΣΤΗΣ POWERBANK
Οδηүίες χρήσης

GB/CY Operating instructions Page 1
HR Upute za upotrebu Stranica 25
RO Instrucţiuni de utilizare Pagina 47
BG Ръководство за
експлоатация Cтраница 69
GR/CY Οδηүίες χρήσης Σελίδα 99
DE/AT/CH Bedienungsanleitung Seite 123
Before reading, unfold the page containing the
illustrations and familiarise yourself with all functions
of the device.
Prije nego što pročitate tekst, otvorite stranicu sa
slikama i upoznajte se na osnovu toga sa svim
funkcijama uređaja.
Înainte de a citi instrucţiunile, priviţi imaginile şi famili-
arizaţi-vă cu toate funcţiile aparatului.
Преди да прочетете отворете страницата с
фигурите и след това се запознайте с всички
функции на уреда.
Πριν ξεκινήσετε την ανάγνωση, ανοίξτε τη σελίδα
με τις εικόνες και εξοικειωθείτε με όλες τις λειτουρ-
γίες της συσκευής.
Klappen Sie vor dem Lesen die Seite mit den Abbil-
dungen aus und machen Sie sich anschließend mit
allen Funktionen des Gerätes vertraut.

2,
2,

SPBW 3000 A1 GB│CY │ 1 ■
Contents
Introduction........................3
Information concerning these operating instructions . 3
Copyright ............................... 3
Notes on trademarks ...................... 4
Intended use............................. 4
Warnings used ........................... 5
Safety ............................6
Basic safety guidelines ..................... 6
Descriptions of components...........9
Start-up ..........................10
Check scope of delivery...................10
Disposal of packaging materials ............11
Charging the Power Bank..................11
Checking the charge level ................. 12
Handling and operation.............13
Charging mobile devices with the Power Bank . 13
Troubleshooting ...................15
Cleaning. . . . . . . . . . . . . . . . . . . . . . . . . .16
Storage when not in use ............16

SPBW 3000 A1
■ 2 │ GB│CY
Disposal..........................17
Disposal of the appliance. . . . . . . . . . . . . . . . . . 17
Appendix.........................18
Technical data ..........................18
Notes on the EU Declaration of Conformity....19
Kompernass Handels GmbH warranty ....... 19
Service ................................23
Importer...............................23

SPBW 3000 A1 GB│CY │ 3 ■
Introduction
Information concerning these operating
instructions
Congratulations on the purchase of your new appli-
ance. You have selected a high-quality product. The
operating instructions are part of this product.
They contain important information on safety, usage
and disposal. Before using the product, familiarise
yourself with all handling and safety guidelines. Use
the product only as described and for the range of
applications specified. Keep these operating instruc-
tions in a safe place. Please also pass these operating
instructions on to any future owner.
Copyright
This documentation is protected by copyright.
Any copying or reproduction, including in the form
of extracts, or any reproduction of images (even in
a modified state), is permitted only with the written
authorisation of the manufacturer.

SPBW 3000 A1
■ 4 │ GB│CY
Notes on trademarks
USB®is a registered trademark of USB Implementers
Forum, Inc.
All other names and products may be trademarks or
registered trademarks of their respective owners.
Intended use
This device is an information technology device and
is intended exclusively for charging mobile devices
that are charged via a USB port as standard.
The appliance is not intended for any other purpose,
nor for use beyond the scope described. This device
is not intended for use in commercial or industrial
environments. The manufacturer accepts no responsi-
bility for damage caused by failure to observe these
instructions, improper use or repairs, unauthorised
modifications or the use of unapproved replacement
parts. The risk shall be borne solely by the user.

SPBW 3000 A1 GB│CY │ 5 ■
Warnings used
The following warning notice types are used in these
operating instructions:
DANGER
A warning notice at this hazard level
indicates an imminently hazardous
situation.
Failure to avoid this hazardous situation could
result in severe injuries or even death.
► Follow the instructions in this warning notice to
avoid the risk of serious injuries or death.
CAUTION
A warning notice at this hazard level in-
dicates a potential for property damage.
Failure to avoid this situation could result in property
damage.
► Follow the instructions in this warning notice to
prevent property damage.
NOTE
► A note provides additional information that will
assist you in using the appliance.

SPBW 3000 A1
■ 6 │ GB│CY
You will find this symbol on the power bank
housing.
► The Power Bank must never be charged and used
for charging an external device at the same time.
► Use only a USB mains adapter with an output
voltage of 5V and an output current of at least
2.1A to charge the power bank.
Safety
In this section, you will find important safety instruc-
tions for using the appliance. This appliance com-
plies with statutory safety regulations. Improper use
may result in personal injury and property damage.
Basic safety guidelines
■ This device may be used by children aged 8 years
and above and by persons with limited physical,
sensory or mental capabilities or lack of experience
and knowledge, provided that they are under super-
vision or have been told how to use the device
safely and are aware of the potential risks. Chil-
dren must not play with the appliance. Cleaning
and user maintenance tasks may not be carried
out by children unless they are supervised.

SPBW 3000 A1 GB│CY │ 7 ■
■ DANGER! Do not allow children to play with
the packaging material! Keep all packaging
materials out of the reach of children.
Risk of suffocation!
■ Check the appliance for visible external damage
before use. Do not operate an appliance that has
been damaged or dropped.
■ Always place the device on a stable and level
surface. It can be damaged if dropped.
■ Do not expose the device to direct sunlight or
high temperatures. Do not cover the device while
charging. Otherwise it may overheat and be
irreparably damaged.
■ Do not place the product near heat sources such
as radiators or other heat-generating devices.
■ Keep the appliance away from open flames
(e.g. candles) at all times.
■ The device is not designed for use in rooms with
high temperatures or humidity (e.g. bathrooms)
or where there is excessive dust.
■ Never expose the device to extreme heat. This
particularly applies to storage in a car. Extreme
temperatures can occur in car interiors and glove
compartments during long periods of immobili-
sation. Remove electrical and electronic devices
from the vehicle.

SPBW 3000 A1
■ 8 │ GB│CY
■ Do not use the device immediately after moving it
from a cold room to a warm room. Always allow
the device to acclimatise before switching it on.
■ Never open the housing of the appliance.
There are no user-serviceable or replaceable
components inside the device.
■ Do not make any unauthorised modifications or
alterations to the device.
■ All repairs must be carried out by authorised
specialist companies or by the Customer Service
department. Failure to make proper repairs may
put the user at risk. It will also invalidate any
warranty claims.
■ Do not expose the device to water spray or drip-
ping water, and do not place liquid-filled objects
such as vases or open drink containers on or near
the device.
■ Switch the device off immediately and disconnect
any connected charging cables from the device
if you smell fumes or notice any smoke. Have the
device checked by a qualified specialist before
using it again.
■ If you are using a USB power supply, the mains
socket used must always be easily accessible so
that the USB power supply can be quickly discon-
nected from the socket in a hazardous situation.

SPBW 3000 A1 GB│CY │ 9 ■
You should also observe the operating instructions
for the USB power supply.
■ DANGER! Mishandling the batteries can cause
fires, explosions, leakages or other hazards!
Do not throw the device into a fire, since the inte-
grated battery may explode.
■ Pay attention to any usage restrictions or prohibi-
tions for battery-powered appliances in locations
with specific hazard risks, such as petrol stations,
aircraft, hospitals etc.
Descriptions of components
(See fold-out page for illustrations)
Power Bank SPBW 3000 A1 (model example)
microUSB charging port (input)
USB port (output)
ON/OFF button
Charge level LEDs
Charging cable (USB to microUSB)
Operating instructions (Symbol image)

SPBW 3000 A1
■ 10 │ GB│CY
Start-up
Check scope of delivery
(See fold-out page for illustrations)
The scope of delivery includes the following
components:
▯ Power Bank SPBW 3000 A1
▯ Charging cable
▯ These operating instructions
♦ Remove all parts of the device from the packaging
and remove all packaging materials.
NOTE
► Check the package for completeness and for
signs of visible damage.
► If the delivery is incomplete or damage has
occurred as a result of defective packaging or
during transport, contact the Service hotline
(see chapter entitled Service).

SPBW 3000 A1 GB│CY │ 11 ■
Disposal of packaging materials
The packaging protects the device from
damage during transport. The packaging
materials have been selected for their
environmental friendliness and ease of
disposal, and are therefore recyclable.
Returning the packaging into the material cycle con-
serves raw materials and reduces the amount of
waste generated. Dispose of packaging materials
that are no longer needed in accordance with
applicable local regulations.
Charging the Power Bank
Before using the Power Bank, the integrated battery
must be fully charged.
CAUTION
► The Power Bank must never be charged and
used for charging an external device at the
same time.
► Due to the high battery capacity and bearing
in mind the charging time, the power bank must
be charged using a USB mains adapter.
► Use only a USB mains adapter with an output
voltage of 5V and an output current of at least
2.1A to charge the power bank.

SPBW 3000 A1
■ 12 │ GB│CY
♦ Connect the USB plug of the charger cable to
a suitable a USB mains adapter (not supplied).
♦ Connect the microUSB plug of the charging cable
to the microUSB charging port on the
Power Bank. An estimate of the charge level is
shown by means of the charge level LEDs .
LED display Charge level
One LED is flashing < 20%
One LED is on, the second LED
is flashing 20–49%
Two LEDs are on, the third LED
is flashing 50–74%
Three LEDs are on, the fourth LED
is flashing 75–97%
All LEDs are on 98–100%
Checking the charge level
You can also check the charge level of the Power
bank when it is not charged or is being used for
charging.

SPBW 3000 A1 GB│CY │ 13 ■
♦ Press the ON/OFF button briefly. The LEDs
show the current charge level of the Power bank
for about 30 seconds.
LED display Charge level
All LEDs are on 98–100%
Three LEDs are on 75–97%
Two LEDs are on 50–74%
One LED is on 20–49%
One LED is flashing < 20%
All LEDs are off 0%
Handling and operation
Charging mobile devices with the
Power Bank
♦ Insert the microUSB plug of the charging cable
into the microUSB charging port of the mobile
device, and insert the USB plug into the USB port
on the Power Bank. The charging process starts
automatically.

SPBW 3000 A1
■ 14 │ GB│CY
♦ If charging does not start automatically, press the
ON/OFF button briefly to start the charging
process.
NOTE
► Alternatively, you can also use the original
charging cable (USB cable) provided by the
respective device manufacturer.
♦ During the charging process, the current charge
level of the Power Bank is shown via the charge
level LEDs (see table in chapter entitled
Charging the Power Bank).
♦ To end the charging procedure, disconnect the
charging cable from the mobile device and
the Power Bank. The charging status LEDs go
off after about 30 seconds.

SPBW 3000 A1 GB│CY │ 15 ■
Troubleshooting
The Power Bank does not charge
♦ Connection may be faulty. Check the connection.
A connected device will not charge
♦ The integrated battery is empty. Charge the battery.
♦ No connection to the device. Check the connection.
♦ Press the ON/OFF button to start the charging
process.
♦ The charging current of the connected device is
too low (< 60 mA) or too high (> 2,1 A).
♦ The internal overcurrent protection may have
been triggered. Disconnect the attached device
and connect the microUSB charging port to
a power source for a short while (see section
Charging the Power Bank). Afterwards, the
Power Bank can be used again.
NOTE
► If you cannot solve the problem with the
above-mentioned solutions, please contact the
Service Hotline (see chapter entitled Service).

SPBW 3000 A1
■ 16 │ GB│CY
Cleaning
CAUTION
Possible damage to the appliance.
There are no serviceable parts or parts requiring
cleaning inside the Power Bank. Moisture can
cause damage to the appliance.
► To avoid irreparable damage to the appliance,
ensure that no moisture can penetrate the
device during cleaning.
► Do not use caustic, abrasive or solvent-based
cleaning materials. These can damage the
surfaces of the device.
♦ Clean the housing of the device with a lightly
moistened cloth and a mild detergent only.
Storage when not in use
♦ Store the device in a location which is clean,
dry, dust-free and not in direct sunlight.
♦ For long-term storage, the integrated battery should
be fully charged to extend its operating life.

SPBW 3000 A1 GB│CY │ 17 ■
Disposal
Disposal of the appliance
The adjacent symbol of a crossed-out
wheelie bin means that this device is
subject to Directive 2012/19/EU. This
directive states that this device may not
be disposed of in normal household waste at the end
of its useful life, but must be brought to a specially
set-up collection point, recycling depot or disposal
company.
This disposal is free of charge for the user.
Protect the environment and dispose of
this device properly.
You can obtain further information from your local
disposal company or the city or local authority.