Simrad PI SeineSounder User manual

Simrad PI SeineSounder
Dual sensor for purse seine and trawl
Simrad PI SeineSounder is a dual sensor for purse seine,
danish seine and trawl. With built-in echo sounder and depth
sensor it does two jobs at the same time!
(CD012205A)
Efcient shery with trawl, purse seine
and danish seine requires correct and
accurate instruments for gear and catch
monitoring.
With the PI SeineSounder Simrad
introduces a new member of the PI
family; a dual sensor that measures
current depth and height above the
seabed - simultanously!
TECHNOLOGY FOR SUSTAINABLE FISHERIES
www.simrad.com

313747 / Rev.B / October 2007
Simrad PI SeineSounder
Applications
Simrad’s PI SeineSounder provides
you with the accurate vertical position
of the gear.
Purse seine
The PI SeineSounder is mounted
vertically below the footrope. From
this position it transmits accurate
information about the height above
the seabed and the depth.
Trawl and Danish seine
The PI SeineSounder is mounted
horisontally behind the headrope.
Technical specications
We reserve the right to alter these
specications without prior warning.
PI systems: PI32, PI44 and PI54
Communication:
• Frequency range: 43,5 to 49, 5 kHz
• Opening angle: 65 degrees
• Source level: 194 dB//1µPa, 1 m
(maximum)
Update rates:
• Fast: 5 seconds
• Normal: 15 seconds
• Slow: 35 seconds
Charging:
• Up to 70% capacity: 1 hour
• Up to 100% capacity: 4 hours
Operational time between charging:
• Fast: Approximately 24 hours
• Normal: Approximately 60 hours
• Slow: Approximately 80 hours
Echo sounder:
• Minimum depth: 70 cm
• Maximum depth: 100 m
(depending on bottom conditions)
• Frequency: 70 kHz
• Opening angle: 55 - 70 degrees
Depth sensor:
• Ranges: 300, 600, 1000 meter
dened by the sensor lid
• Accuracy: 0,25% of the depth
Physical dimensions:
• Length: 300 mm
• Width: 205 mm
• Thickness: 131 mm
• Weight in air: 7 kg
• Weight in water: 2,7 kg
Sensor key
In order to use the PI SeineSounder
both vertically on a purse seine and
horizontally on a trawl, the echo
sounder inside the sensor is equipped
with two transducers. Before you use
the sensor you must therefore “set
it up” with one of the sensor keys.
These are two special bolts provided
in a gift box.
• LONG bolt for purse seine
• SHORT bolt for trawl
The bolts are screwed rmly in,
but not tightened. Note that ordinary
bolts can not be used!
Kongsberg Maritime AS
Strandpromenaden 50
P.O.Box 111
N-3191 Horten, Norway
Simrad
Telephone: [phone]
Telefax: [phone]
[e-mail]
www.simrad.com