SMITH SYSTEM 26672 User manual

If you have damaged or missing components please
Form# 179862 contact customer service. 04/2014
800-328-1061
www.smithsystem.com

If you have damaged or missing components please
Form# 179862 contact customer service. 04/2014
800-328-1061
Special Notes
1. Check that all components are accounted for and undamaged before assembling.
2. Please assemble product in a clean and dry area.
3. For larger units, you may need another person to help assemble the product.
4. Clean the product with a mild cleaner and a damp cloth.
Hardware and Components
*Our Circulation Workstations come in different lengths and shapes, so hardware and screw hole
placement will vary. If you feel you have not received all of the necessary hardware, please call us at
800-328-1061.
Replacement pack (Qty. 2) 69755 includes:
77471 (Qty. 16) 1/4-20X1/2” Combo Drive Machine Screw
70226 (Qty. 8) 10-32X1/2” Machine Screw
77482 (Qty. 2) Tinnerman Clip
70054 (Qty. 16) SM Screw #10X3/4 HI/LO PTH
#10 Wood Screw
(Qty. 16)*
P/N-70054
10-32X1/2” Machine Screw
(Qty. 4)*
P/N-70226
10-32X1/2” Machine Screw
(Qty. 24)
P/N-77471
Leg Set (Qty. 1)
(2 legs per set)
Table Top (Qty. 1)
Tinnerman Clip
(Qty. 4)
P/N-77482
Modesty Panels (Qty. 2)*
Corner Leg (Qty. 1)

If you have damaged or missing components please
Form# 179862 contact customer service. 04/2014
800-328-1061
Assembly Instructions
Step 1: Locate all of the parts needed for assembly. Place the table top face down on a clean, dry
surface. Align the corner leg and the side leg sets with the predrilled holes in the top.
Step 2: Now adjust the corner leg to the desired height using (4) ¼-20X1/2” Machine Screws. Next adjust
the side legs using (8) ¼-20X1/2” Machine Screw to desired height.

If you have damaged or missing components please
Form# 179862 contact customer service. 04/2014
800-328-1061
Step 3: Now Install (1) Tinnerman Clip per leg, in the square hole located inside of the leg. Next Install (4)
Tinnerman Clips at the top and the bottom of the corner leg.
NOTE: Tinnerman Clips are only used if the desk is raised to a high range, when set to a low range the
threaded hole for the lower leg will be used instead of the Tinnerman Clips.
Step 4: Once the legs are secure, loosely attach the modesty panel to the side legs using (4) ¼-20X1/2”
Machine Screw. Now use the remaining (4) Machine Screws to loosely attach the modesty panel to the
corner leg.

If you have damaged or missing components please
Form# 179862 contact customer service. 04/2014
800-328-1061
Step 5: Attach the leg sets, the corner leg, and the Modesty panel to the top using the wood screws
provided.
Step 6: Go back and tighten all of the screws referenced in step 4. With help, flip the desk into the
upright position. Your desk is now ready for use.