SMITH SYSTEM Elemental 01475 User manual

For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179938 04/2013

For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179938 04/2013
Special Notes:
1. Check that all components are accounted for and undamaged before assembling.
2. Please assemble product in a clean and dry area.
3. For larger units, you may need another person to help assemble the product.
4. Clean the product with a mild cleaner and a damp cloth.
Tools Required:
1. Hammer
2. Wooden block or something to absorb direct impact of hammer
Hardware and Components
Replacement Hardware Pack:
1. 67612-R – EOB Dog Hardware Pack
a. (4) 77741 – 3/8-16x.625 Half Dog Socket
b. (4) 70054 – SM Screw #10x.75 Hi/Lo PTH
c. (1) 77813 – Hex Key – 3/16” Short Arm
Open Front Book Box attached to top
QTY: 1
Leg Insert
QTY: 4
Leg Stem
QTY: 4
3/16” Set Screw
P/N: 77741
QTY: 4
Hex Key 3/16” Short Arm
P/N: 77813
QTY: 1

For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179938 04/2013
Assembly Instructions
Step 1: The leg stems are inserted into each of the 4 sockets of the
Plastic Box. The leg stem has a metal key which extends outward
slightly from the leg (Shown in Picture #1). The key must line up with
the slot on the plastic box.
**This step is crucial to leg installation.**
Step 2: With the leg stem aligned to the hole as provided in Step, the
leg must be hammered into place. Use a brace between the leg and
the impact of the hammer to protect the leg tube.
(A wood block is shown.) (See Picture #2)
With all 4 leg stems hammered into place, reassemble the leg
Insert into the leg stem, and use the set screws to set the height.
(as shown in Picture #4) Your Table is now ready for use.
Picture #1
Step 3: When the leg is fully set into place, the measurement
from the box to the top of the leg stem is 10 inches.
Picture #2
Picture #4
Picture #3