SMITH SYSTEM Acrobat 26550 User manual

If you have damaged or missing components
please contact customer service.
Form# 179954 800-328-1061 02/2013
(Model # 26550, 26551)

If you have damaged or missing components
please contact customer service.
Form# 179954 800-328-1061 02/2013
Hardware and Components
Replacement Hardware Pack 69755 Includes:
(16) 77471- 1/4-20X1/2”Combo Machine Screw
(8) 70226- Machine Screw 10-32X.5
(2) 77482- Tinnerman Clip
(16) 70054- SM Screw #10X.75 Hi/Lo Pth
#10 Wood Screws
(Qty. 18)
P/N-70054
10-32X1/2”Machine Screws
(Qty. 8)
P/N-70226
¼-20X1/2”Machine Screws
(Qty. 8)
P/N-77471
3/8”–Dog Nut Screw
(Qty. 2)
P/N-77741
Allen Wrench
(Qty. 1)
P/N-77813
Tinnerman Clip
(Qty. 1)
P/N-77482
½” Nut
(Qty. 2)
Acrobat Leg w/ Bracket
(Qty. 2)
P/N- 26656
Acrobat Modesty Panel
(Qty. 2)
Crescent Table Top
(Qty. 1)

If you have damaged or missing components
please contact customer service.
Form# 179954 800-328-1061 02/2013
Step 1: On a clean flat surface, flip the top upside down so that the pre-drilled holes are visible. As
shown in figure 1, attach the two modesty panels to the center leg using the large 1/4-20 machine
screws (2 per panel). Do not tighten completely.

If you have damaged or missing components
please contact customer service.
Form# 179954 800-328-1061 02/2013
Step 2: Adjust the left and the right leg to the desired height by removing the 4 machine screws in each
leg and re-attach them securely (figure 2A). if a high range is required, install the Tinnerman Clips into
the square openings (one per leg). As shown in figures 2&2B, attach the two legs to the modesty panels
using the large 1/4-20 machine screws. Do not tighten completely.
Step 3: With the legs and the panels assembled loosely, align them with the pre-drilled holes and attach
them to the top with the supplied wood screws. Now tighten the machine screws between the legs and
the panels.
Step 4: Adjust the height of the center leg by loosening the two allen drive screws using the supplied hex
key and the ½” nuts. Pull upward on the lower leg section to the desired height and re-tighten the
hardware.