SMITH SYSTEM NUMBERS 02130 User manual

Assembly Instructions
NUMBERS DESKS
If you have damaged or missing components,
please contact customer service at 1-800-328-1061
Document #: 179722 REVISED: 12/2021
MODEL NUMBERS
02130, 02131, 02132, 02133, 02140, 02141,
02142, 02143

Hardware and Components
REVISED: 12/2021
Document #: 179722
OPTIONAL ACCESSORIES
2” LOCKABLE CASTER
QTY. 3 OR 4
T25 TORX POWER BIT 2”
QTY. 1
NUMBERS DESK LEG CUSTOM SET SCREW
3/8-16 X ¾”
QTY. 2 PER INSERT
1/8” ALLEN KEY
QTY. 1
LOW RANGE INSERT
QTY. 3 OR 4
NO. 10X1-1/8” TORX BUTTON HEAD SCREW
QTY. 8 PER LEG ASSEMBLY
NUMBERS SINGLE LEG ASSEMBLY
QTY. 3 OR 4

Special Notes:
•Check that all components are accounted for and undamaged before assembling.
•Please assemble the product in a clean and dry area.
•Clean the product with a mild cleaner and a damp cloth.
Document #: 179722 REVISED: 12/2021

A notch in the leg insert tube
was created to help align the
set screw visually.
Assembly Instructions
Document #: 179722 REVISED: 12/2021
1. Place wood top on clean smooth surface upside down with the pilot holes facing up.
Align holes in the single legs with the pilot holes. Using the included T25 torx bit fasten
all single leg assemblies using 8x NO. 10X1-1/8” torx button head screws per leg.
2. To adjust the table height, use the supplied 1/8” Allen Key, the numbers leg sets uses
a hidden fastener to adjust the legs. This set screw can be access through adjustment
holes as shown below. Turn the set screw clockwise to loosen and counterclockwise
to tighten the inserts in place. The set screw will fit inside the adjustment hole to set
the table height.
The set screw will fit inside the
adjustment hole to set the table height.

Assembly Instructions
Document #: 179722 REVISED: 12/2021
3. To change the leg set to the optional glide version, turn the set screw clockwise until it
stops, remove the leg insert and rotate 180 degrees inserting the glided side of the leg
set into the tube first. Follow step 2 to set the leg height and tighten the insert into place.
Install press in caster as shown.
Orientation of tube
shown outside of
assembly for
reference