SMITH SYSTEM 27344 User manual

For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179773 04/2013
Graphic Arts Table
Assembly Instructions
Model
27344
27345
27346
27347
27348

For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179773 04/2013
Hardware and Components
5/8” #10 Wood Screw
P/N: 70080
(QTY: 16)
P/N: 70868 –¼-20x30mm Connector Bolt
P/N: 70869 –¼-20x17mm connector Nut
(QTY: 8)
Sheet Metal Screw
(QTY: 1)
Cable Assembly
(QTY: 1)
Allen Wrench 3/16”Short Arm
P/N: 77813
(QTY: 2)
3/8”-16x.625 Set Screw
P/N: 77741
(QTY: 8)
Beaver Tail
P/N: 72741
(QTY: 1)
GA Leg Set
P/N: 72735
(QTY: 1 set)
GA Top w/ Braces
(QTY: 1)
Easel Clip
(QTY: 1)
Spacer Clip
Only Models 27344,
27345, 27346
Pencil Retainer
P/N: 78083
(QTY: 1)
Replacement Hardware Pack:
74119 –Library/New Style GA HDWR Pack:
1. (4) 70868 - ¼-20x30mm Connector Bolt
2. (4) 70869 –¼-20x17mm connector Nut
3. (2) 77813 –Allen Wrench 3/16”

For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179773 04/2013
Assembly Instructions
Step 1: NOTE: You will assemble the legs while the top assembly is still in the shipping box. Remove the
filler pieces on each end; this should allow some working room to attach the legs. You may break down
the short ends of the box to gain more access to the ends. Attach the legs to the front brace and rear
brace. Make sure the pinholes on the legs face the desk. Use (4) Connector bolts, (2) per leg (See Picture
1 and 2).
Pinhole facing inward
Picture 1
Picture 2

For Assistance in assembling product, missing or damaged parts,
or to place an order, please contact customer service at 800-328-1061
You may also place your order online at
www.smithsystem.com
Form# 179773 04/2013
Step 2: Attach the cable. Take the loose end of the cable and set it flush against the pilot hole on the leg.
Using a Phillips head screwdriver, or an electric screwdriver, attach the eyehole of the cable with the
sheet metal screw to the leg (See Picture 3).
Step 4: Leg Adjustment: Legs are set to a standard height upon arrival. If you require a different height,
use the provided allen wrench to loosen the set screws, set the leg stem to the height, and re-tighten
the set screw (See Picture #4).
Picture 3
Picture 4