SMITH SYSTEM Trespa Top 11265 User manual

If you have damaged or missing components
please contact customer service.
800-328-1061
www.smithsystem.com
Form #179785
WARNING: READ THIS FIRST
IF YOU ARE ATTEMPTING TO ASSEMBLE THIS
TRESPA TOP PLEASE MAKE SURE YOU ARE
USING THE CORRECT SCREW.
USING THE INCORRECT SCREW WILL CAUSE
PERMANENT DAMAGE TO THIS TOP.
SMITH SYSTEM WILL NOT BE LIABLE FOR ISSUES
RESULTING FROM USING THE INCORRECT SCREW
IF INCORRECT SCREWS WERE INCLUDED WITH THIS TOP
OR YOU CANNOT LOCATE CORRECT HARDWARE,
CONTACT SMITH SYSTEM CUSTOMER SERVICE AT THE
NUMBER BELOW.
CORRECT / FLAT TIP INCORRECT / POINTED TIP

Trespa Top Quick Installation Guide
NOTE: Because of variations in Drill Drivers you may
need to reduce the Torque Setting on your
particular model to prevent over tightening.
Instructions
Step 1: Following the Instructions included with the
desk frame, loosely assemble frame (finger tight).
Step 2: Flip Trespa Top over on a smooth,
clean surface with the bottom facing up.
Step 3: Align the frame assembly with the pilot holes
in the Trespa Top.
Step 4: Loosely install the supplied #10 Plastite screws
in each of the pilot holes.
Step 5: Using the supplied Allen wrench go back and
tighten bolts in frame assembly.
Step 6: Set the Torque Setting of your Drill Driver to
approximately (18) or (75% of maximum). Go back and
tighten all of the #10 Plastite screws being careful not to
over tighten as this may cause the hole in the plastic top to
strip-out. DO NOT OVER-TORQUE
Required for Installation
#10 x 7/16” Plastite Screw
MODELS
11265 11268 11271 25705 25715 25725
25735
If you have damaged or missing components
please contact customer service.
800-328-1061
www.smithsystem.com
Form #179785