SMITH SYSTEM 26680 User manual

For assistance in assembling product, or to place
An order please contact customer service at
Form# 179873 800-328-1061 02/2013
Library Carrels
Assembly Instructions
(Starter Unit) See Instruction Sheet 179874 for Adder Unit
Model
26680
26682
26684

For assistance in assembling product, or to place
An order please contact customer service at
Form# 179873 800-328-1061 02/2013
Special Notes
1. Check that all components are accounted for and undamaged before assembling.
2. Assemble product in a clean and dry area.
3. Due to size, we recommend that two people should be involved in assembling product.
4. Clean the product with a mild cleaner and a damp cloth.
Tools
You will need a Phillips head screwdriver.
Hardware and Components
Replacement Pack 74125 Includes:
(12) 70080- 10x5/8 Truss Head Phillips Head
(6) 70869- Connector Nut ¼-20X17mm
(6) 70870- Connector Bolt ¼-20X23mm
(4) 70226- Machine Screw 10-32X.5
(2) 77813- Hex Key- 3/16” Short Arm
#10 Wood Screws
(Qty. 12)
P/N-70080
Phillips Head Machine Screws
(Qty. 4)
P/N-70226
Connector Bolts (Qty. 6)
P/N-70869- Connector Bolt ¼-20X17mm
P/N-70870- Connector Nut ¼-20X23mm
Allen Wrench
(Qty. 2)
P/N-77813
Cross Brace
(Qty. 1)
Back Panel (Qty. 1)
Top (Qty. 1)
Brackets (Qty. 2)
P/N-73061
Left Panel (Qty. 1)
Right Panel (Qty. 1)

For assistance in assembling product, or to place
An order please contact customer service at
Form# 179873 800-328-1061 02/2013
Assembly Instructions
Library Carrels (Starter Unit)
URGENT: Back panel orientation determines the top height. By rotating 180 degrees, you can
change the carrel to the desk height or the kiosk height.
*Due to size, we recommend that two people should be involved in assembling the product
Step 1: With help, lay the right and the left panels on the floor while aligning the cross bar with the
pilot holes. Attach together by using (4) Phillips Head Machine Screws (See Drawing 1A & Note).
“C”brace on
back panel
Left Panel
Right Panel
*Note:
Attach the panels so that the
6 pre-drilled bracket holes
are inside.

For assistance in assembling product, or to place
An order please contact customer service at
Form# 179873 800-328-1061 02/2013
Step 2: Slide the back panel in-between both panels with the bracket facing up. Verify alignment
with the pilot holes and attach using (6) Connector Bolts (See Drawing 2A). Next, attach the brackets
to either kiosk or desk height by using (6) Wood Screws (See Drawing 2B).
Step 3: Set the unit upright on its feet and slide the work surface above both Brackets until it runs
flush against the back panel. Align the predrilled holes underneath the table top with the brackets.
Using (6) Wood Screws, attach the top to the brackets (See Drawing 3A).
-
Drawing 2A
Drawing 2B
Back Panel orientation determines
the top height. By rotating 180
degrees, you can change the carrel
to desk height or kiosk height.
*28”Desk Height
*36”Kiosk Height
Drawing 3A