Snom D7 Series User manual

1.
2.
3.
4.
5.
Get the snom phone ready for operation
Connect
First of all, unpack your Snom Phone and put it on the table.
To connect it use the enclosed network cable and connect the " " socket of your telephone to your network switch. The Net port is usually inNet
the center of the 7 series devices. On devices of the 3 series, it is usually on the left.
To get power for your Snom Phone either a network switch with " " (Power over Ethernet) or a suitable Snom power supply (A6) unitPOE
(usually 5V - No guarantee for damage when using an external power supply).
At the " " socket you can connect your computer to the workstation.PC
When connecting the handset to the phone, please note that the short end is connected to the handset and the long end is plugged into the
"handset" jack of the phone.You need the longer part for strain relief.
These ports support 802.1X authentication.

Mount the Footstand - D7xx Series
The base of the 7 series can be mounted for the usual standing position and for a lying position.
For the classic standing position, you have to slide the short end of the foot down and the long one to the right from below into the rails of the
phone until it locks.
For the lying position, do it almost the same way, except that the long side must face down and the short one to the right.
Mount the Footstand - D3xx Series
Mounting the foot on a device of the 3 series is much easier. As you can see in the picture, you place the latches of the foot, which are located on
the very outside at the back, on the rear openings of the phone and then snap the foot forward with a click.

Related articles
Hallo. ich habe mehrere gebrauchte D715 erworben. Die lassen sich aber nicht zurücksetzen und machen Autoprovisioning in der virtuellen
Anlage des Vorbesitzers. Ein Admin Login geht auch nicht und keiner mehr kennt das Passwort. Was kann ich tun ?
Snom D305 Admin Passwort
Hello,
Wie Kennung für Pickup-Monitoring
Not able to register D765 with TLS to FreePBX 15
Desk Phones
Autoprovisioning failled
D785 Display zeigt Namen aus Adressbuch statt Nebenstelle
Firmwareupdate für D120 Tischtelefon
Hi. Just setup a D713. Each time I attempt to make a call it restarts with "mediastack restarting" message. Have upgraded to latest firmware.
Unregistered after autoprovisioning
D717 - WLAN Connection
Wie kann man beim D385 DTMF aktivieren, wenn man z.B. an ein CC gerät...?
Telefonbuchdownload D785 Firmware 10.1.84.12 und höher
Snom D120 - Ethernet Unplugged
Please note the following instructions for securing your Snom phone after you have put it into operation: How do I secure my Snom phone
Further Information
VoIP Essentials
Visit the Snom Forum
Open a support ticket
Find a local partner