Steelcase Avenir KD Desk User manual

Avenir™KD Desk
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2013 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
®
Page 1 of 6
939503323 Rev B
3/8" HEX
SOCKET
#2 PHILLIPS BIT

Page 2 of 6
939503323 Rev B
®
Panel Installation
1. Flip the worksurface over onto a clean, non-abrasive
surface.
2. Position end panel on worksurface, Ensure end
panel is flush at front and end. Align mounting holes
to pre-drilled holes in worksurface and attach with
hardware supplied .
3. Attach the modesty panel to the end panel
with hardware supplied.
NOTE: The distance between the back of the modesty
panel and back of the worksurface is 1-1/4”. Do not
attach modesty panel to worksurface at this time.
2
3
1
END PANEL
MODESTY PANEL
WORKSURFACE

Page 3 of 6
939503323 Rev B
1. Pull drawer forward.
2. Push on tab on each side of the
drawer rails.
3. Remove drawer completely.
4. Push drawer rails back into
pedestal.
5. Remove remaining drawers.
TIP: Mark all drawers so they can be
easily re-installed in their original
positions.
Drawer Removal
1
3
2
4

Page 4 of 6
939503323 Rev B
®
1
2
Pedestal Installation
1. Flip the ped over onto the worksurface
and align. It should be flush to the side of the
worksurface and 1” from the front of the
worksurface.
2. Secure the pedestal to the worksurface
with four (4) 1/4-14 x 1" wood tapping screws.
4 SCREWS
1”

Page 5 of 6
939503323 Rev B
®
Pedestal Installation
3. Attach the pedestal to the modesty panel.
Note the distance between the back of the
modesty panel and the back of the
worksurface is 1-1/4”.
4. Attach modesty panel to the worksurface.
3
4
1-1/4”

Page 6 of 6
939503323 Rev B
®
Place Desk Upright
Rotate desk upright. Be sure to rotate the
modesty panel to the floor and then rotate
into the upright position.
IMPORTANT: DO NOT rotate desk
towards the pedestal frame or tip desk on
end to minimize twist in desk.
NOTE: This will require two (2) people.
Drawer Re-Assembly
1. Verify that drawer rails are pushed
back into pedestal.
2. Pull ball cages on drawer rails to front
of drawer rails.
3. Carefully align drawer portion of rail
with ball cage of pedestal portion of rail
and gently push drawer back into
pedestal.
TIP: Failure to re-assemble drawers
correctly may damage rails, rendering
them non-functional.
Level the desk unit using the leveling
glides on the pedestal and end panel.
1
23