SOMFY inteo EOLIS RTS User manual

The EOLIS sensor RTS is a radio sensor for awnings with a protection against
wind damage.
The wind threshold can be set directly on the EOLIS sensor RTS.
The EOLIS sensor RTS has to be used with the OREA RTS and ALTUS RTS
motors.
®
Mains supply : 220-240 V~ 50/60 Hz
Protection index : IP34
Operating temperature : -20°C to +50°C
Class II product once installed
(Find in annex the CE declaration of conformity)
inteo EOLIS sensor RTS
INSTALLATION guide
Ref.9000839
Installation:
1
,,,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,,,
,,,,,,,,,
,,,,,,,,,
,,,,,,,,,
,,,,,,,,,
,,,,,,,,,
,,,,,,,,,
,,,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,
,,,
,,,,,,
,
,,,,
,
,
,,,,
,
,
,,,,
,
,
,,,,
,
,,,,,,
,,,,,,
,
,,,,
,
,
,,,,
,
,
,,,,
,
,,,,,,
Press more than 2 seconds
on the programming button of
a RTS control which is already
memorized in the motor.
(please refer to the installation guide of
the concerned motor).
Press briefly on the
“prog”button of the
EOLIS sensor RTS.
➜
236 mm
160 mm
Connect the cable
to the terminal. Put the
cover Fix the sensor
to the wall. Put and screw
the front box.
MAINS
230V - 50Hz
2 wires x 0,75 mm2
Neutral
Phase
>2 sec.
prog
The motor must be in its learning mode to record an EOLIS sensor RTS.
Up to three EOLIS sensors RTS can be memorized in a motor and one EOLIS sensor RTS can be memorized in several motors.
Programming:
2
Characteristics
Mounting Cabling
The awning moves shortly
(DOWN/UP).
the motor is in “learning”mode.
Enter the “learning” mode Record or delete a sensor
The awning moves shortly (DOWN/UP).
If it is a new sensor : it will be recorded in the motor.
If the sensor was already recorded : it will be erased.
Press more than 7 sec. on
the“prog”button of the
new EOLIS sensor RTS.
Erase all the sensors and record a new one
The awning moves shortly (DOWN/UP).
the memory of the receiver is cleared (all the
previous sensors are erased) and the new sen-
sor is recorded.
prog
>7 sec.
➜
➜
0165

The EOLIS sensor RTS is able to protect an awning regarding the WIND by controling the OREA RTS or the ALTUS RTS motors.
The WIND threshold can be adjusted by a potentiometer accommodate wind speed between 10 to 50 Km/h.
As long as the
measured
wind speed is
higher than the
adjusted threshold, any order is inhibited.
When the wind
speed exceeds the
threshold set by the
EOLIS sensor RTS,
an UP order is given
to the awning after
2 sec.
In this mode all delay times are reduced to ease
installation and the wind threshold is 10Km/h.
The mode is selected by turning the wind poten-
tiometer clockwise to the limit.
after 2 sec.
When the wind
speed falls
below the thre-
shold setting, an
order can be
given with the RTS control after 30
sec..
after 30 sec.
Functionning:
3
®
WIND function
DEMO mode Temporisations (with OREA and ALTUS)
Normal mode Demo mode
WIND appearing timing 2 sec. 2 sec.
WIND disappearing timing 30 sec. 12 min. 15 sec.