SOMFY inteo EOLIS User manual

The EOLIS sensor RTS is a radio sensor for awnings with a protec-
tion against wind damage.
The wind threshold can be set directly on the EOLIS sensor RTS.
The EOLIS sensor RTS has to be used with the OREA RTS and
ALTUS RTS motors.
Mains supply : 220-240 V~ 50/60 Hz
Protection index : IP34 (cable bushing not drilled. Only guaranted if professionally
installed).
Operating temperature : -20°C to +50°C
Class II product once installed
inteo EOLIS sensor RTS
INSTALLA
TION
guide
Installation:
1
Pressmore than 2
seconds on the pro-
gramming button of a
RTS control which is
already memorized in the
motor.
(please refer to the installation
guide of the concerned motor).
Press briefly on
the “prog” button
of the EOLIS
sensor RTS.
➜
Connect the cable
to the terminal. Put the
cover Fix the sensor
to the wall. Put and screw the front box.
>2 sec.
The motor must be in its learning mode to record an EOLIS sensor RTS.
Up to three EOLIS sensors RTS can be memorized in a motor and one EOLIS sensor RTS can be memorized in seve-
ral motors.
Programming:
2
Characteristics
Mounting Cabling
The awning moves
shortly (DOWN/UP).
the motor is in “learning”
mode.
Enter the “learning” mode Record or delete a sensor
The awning moves shortly
(DOWN/UP).
If it is a new sensor : it will be recorded in the
motor.
If the sensor was already recorded : it will be era
-
sed.
Press more than 7
sec. on the “prog” but-
ton of the new EOLIS
sensor RTS.
Erase all the sensors and record a new one
The awning moves shortly
(DOWN/UP).
the memory of the receiver is cleared
(all the previous sensors are erased)
and the new sensor is recorded.
>7 sec.
➜
➜
Hereby, SOMFY, declares that this equipment is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.
A Declaration of Conformity is available at the web address www.somfy.com
Heading CE

The EOLIS sensor RTS is able to protect an awning regarding the WIND by controling the OREA RTS or the ALTUS
RTS motors.
The WIND threshold can be adjusted by a potentiometer accommodate wind speed between 10
to 50 Km/h.
As long as
the measu-
red wind
speed is higher than the
adjusted threshold, any order is inhi-
bited.
When the wind
speed exceeds
the threshold set
by the EOLIS
sensor RTS, an
UP order is
given to the
awning after 2 sec.
In this mode all delay times are reduced to
ease installation and the wind threshold is
10Km/h.
The mode is selected by turning the wind
potentiometer clockwise to the limit.
after 2 sec.
When the
wind speed
falls below
the threshold
setting, an
order can be given with the RTS
control after 30 sec..
after 30 sec.
Functionning:
3
WIND function
DEMO mode Temporisations (with OREA andALTUS)
Normal mode Demo
mode
WIND appearing timing 2 sec. 2 sec.
WIND disappearing timing 30 sec. 12 min. 15 sec.