Spinmaster Cool Maker User manual

Check Out
For How-To
Videos!
@coolmaker
SEW N’ STYLE MACHINE
+
6VISIT:
www.coolmaker.com
YEARS

02
IMPORTANT: Do not use fabrics other than those supplied or
recommended by the manufacturer for sewing.
For indoor dry locations use only. Clean the product with a dry cloth
only. Always use under adult supervision.
Do not store or use product near heat, sparks or flame.
a CAUTION: Use machine on a flat surface.
a CAUTION: Do not give the plush dolls or accessories that
are made by the Cool Maker™ Sew N’ Style Machine to
children under 3 years.
a CAUTION: The fabric and stuffing materials provided may
cause suffocation.
a CAUTION: This toy uses sharp needles (already assembled).
• Do not use if protective needle shroud is cracked or broken.
• NEVER use if any needles are bent or broken.
•Intheunlikelyeventthataneedlebreaksduringuse,ensurethatthe
needle fragment is found and removed safely.
• Do not attempt to dismantle or rebuild the machine.
• Never open the main motor case of the machine.
• Do not submerge the unit or any other parts in water or use on wet
surfaces.
FCC STATEMENT: This device complies with Part 15 of the FCC
rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including
interference that may cause undesired operation. This
BATTERY INFORMATION
equipment has been tested and found to comply with the limits
for Class B digital devices pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable protection
against harmful interference to radio communications. This
equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instruction, may cause harmful interference to radio
communication. However, there is no guarantee that
interference will not occur in a particular installation. If this toy
does cause interference to radio or television reception (you
can check this by turning the toy off and on while listening
for the interference), one or more of the following measures
may be useful: - Reorient or relocate the receiving antenna-
Increase the separation between the toy and the radio or the
TV- Consult the dealer or an experienced TV-radio technician
for help. NOTE: Changes, adjustments or modifications to this
unit, including but not limited to, replacement of any transmitter
component (crystal, semiconductor, etc) could result in a
violation of FCC rules under part 15 and/or 95 and must be
expressly approved by Spin Master Ltd or they could void the
user’s authority to operate the equipment.
CAN ICES3B)/NMB3B)

03
HOW TO INSTALL BATTERIES: Ensure machine is in
OFF position.
1. Open the battery door with a screwdriver.
2. Ifusedbatteriesarepresent,removethesebatteriesfromtheunit
bypulling up on one end ofeachbattery.DO NOTremoveorinstall
batteries using sharp or metal tools.
3. Install new batteries as shown in the polarity diagram (+/-)
inside the battery compartment.
4. Replace battery door securely.
5. Check your local laws and regulations for correct recycling
and/or battery disposal.
BATTERY SAFETY INFORMATION: Batteries are small objects.
Replacement of batteries must be done by adults. Follow the
polarity (+/-) diagram in the battery compartment. Promptly
remove dead batteries from the toy. Dispose of used batteries
properly. Remove batteries for prolonged storage. Only
batteries of the same or equivalent type as recommended are
to be used. DO NOT incinerate used batteries. DO NOT dispose
of batteries in fire, as batteries may explode or leak. DO NOT
mix old and new batteries or types of batteries (i.e. alkaline/
standard/rechargeable). Using rechargeable batteries is
not recommended due to possible reduced performance.
Rechargeable batteries are only to be charged under adult
supervision. Replaceable-rechargeable batteries are to be
removed from the toy before being charged. DO NOT recharge
non-rechargeable batteries. DO NOT short-circuit the supply
terminals. Requires 4 x AA 1.5 V (LR6) batteries (not included).
Batteries or battery packs must be recycled or disposed of
properly. When this product has reached the end of its useful
life it should not be disposed of with other household waste.
The Waste Electrical and Electronic Equipment Regulations
require it to be separately collected so that it can be treated
using the best available recovery and recycling techniques.
This will minimize the impact on the environment and human
health from soil and water contamination by any hazardous
substances, decrease the resources required to make new
products and avoid using up landfill space. Please do your part
by keeping this product out of the municipal waste stream!
The “wheelie bin” symbol means that it should be collected as
“waste electrical and electronic equipment”. You can return an
old product to your retailer when you buy a similar new one. For
other options, please contact your local council.
+
–+
–
4 x AA batteries
Cover
BATTERY INFORMATION

04
1 Cool Maker™ Sew N’Style Machine
2 Sheets of Glitter Fabric
2 Cool Maker™ Pre-cut Projects
1 Sheet of Cool Maker™ Felt Fabric
3 Cool Maker™ Decorative
Fabric Pieces
1 Page of Pop-out Patterns
1 Pom Pom MakerAttachment
1 Piece of Stretch Fabric
1 Bag of Stuffing
1 Elastic
1 Bundle of Ribbon
(3/8”x 50”/ 0.9 cm x 127 cm)
1 Bundle of Style String
(252” / 6.4 m)
2 Bundles of Pom Pom Yarn
(96”/ 2.4 m Bundle)
1 Playbook
CONTENTS
Glitter Fabric
Felt Fabric
Pre-cut
Projects
Pom Pom Maker
Attachment
Decorative Fabric
Pieces
Stuffing
Pop-out
Patterns
Elastic
Stretch
Fabric
Pink
Ribbon
Blue Pom Pom Yarn
Pink Style
String

05
Diagram:
Manual Knob
Style String
Guide
Style String Guide
Seam Guide
Fold Guide
Pom Pom Maker
Attachment
ON/OFF Switch
Start/Stop Button
Storage Drawer
DIAGRAM
*Requires 4 AA
(LR6) Batteries
Not Included.
Needle Guard
Light

06
BASIC SEWING TIPS
1
2
34
@coolmaker
Basic Sewing Tips:
Follow these steps when
creating projects:
1. Turn ONOFF switch to ‘I’.
2. Press STARTSTOP button to
start the machine.
3. Make sure to slowly feed the
fabric under the needle guard and
follow the seam guides.
4. To stop sewing, press the STARTSTOP button. To
turn off the machine turn the OFF switch to ‘0’.
TIP : Have ruler,
scissors and
pencil handy
before starting
your project.

07
STYLE STRING SEWING TIPS
Style String
Sewing Tips:
For Glitter &
Stretch Fabric:
Turn ONOFF switch
to ‘I’.
1. Unravel an arm’s
length of style string
from the spool.
1
2
3
4
5
2. Thread style string through the guides on top
of the machine.
3. Guide the style string underneath the needle
guard.
4. To start sewing press the start button.
5. Follow step 3 and 4 from page 6.
6. Cut style string at seam edge.

08
CREATE A POM POM
Insert the pom pom attachment into
the machine.
Tie 8”/20 cm piece of yarn around
the wrapped prongs.
Use scissors to cut the looped ends.
Fluff and trim. Do not cut the middle tie.
Wrap the remaining yarn
around both prongs.
Cut 8”/20 cm piece of pom pom yarn and
set aside to use in step 4.
1
4
23
6
5
Remove from the pom pom maker and
tie double knots with remaining yarn.

09
CREATE A POM POM
Create a
Pom Pom
Tie onto Glitter Pouch.
Tie onto Hair
Clip Holder.
TIP: For better results,
ask an adult to help tie a
tighter knot.
Check Out
@coolmaker
for How-To Videos!

PLUSH UNICORN
10
Scrunch one end of the glitter fabric. Place on top layer of felt and
sew with style string. Repeat with smaller piece of glitter fabric to
create layered skirt.
Using the two unicorn pop-out
patterns, trace and cut two
pieces of pink glitter fabric.
3
4
Remove style string, and sew the unicorn
front and back layers together. Notice the
symbols that show where to START (1), STOP
(2), and spot stitch (+) on the back panel.
Do not stitch over glitter fabric skirt.
Prepare the pieces you will need.
12

PLUSH UNICORN
11
1
Stuff your character through the
bottom opening. DO NOT OVERSTUFF.
Stitch the stuffed character closed, from (2) to (1).
TIP: If the seam comes
apart, sew over the
stitching path again.
Plush
Unicorn
PROJECT
5
6
*Follow similar steps to
create butterfly plush.
Check Out
@coolmaker
for How-To Videos!

GLITTER POUCH
12
Prepare the pieces you will need.
Fold glitter fabric in half, top folded seams
facing up. Sew left and right seams, stopping
at the style string.
Fold short end of glitter fabric over 1” / 2.5 cm.
Using the fold guide, sew in place
with style string. Repeat for the other side.
Fold one end of the ribbon over the pom
pom prong. This will help guide the
ribbon through the top seam.
Cut two pieces of ribbon, double the
length of the pouch opening.
1
3
2
4
5
TIP: Have pom
pom attachment
handy before
starting this
project.

GLITTER POUCH
To create the drawstring closure, repeat steps 5-8 with the second ribbon,
starting on side without the knot.
To complete pouch,
flip inside out.
9
10
6
7
Check Out
@coolmaker
for How-To Videos!
Tie the two ribbon ends together as
shown.
8
13
PROJECT
Glitter
Pouch
Insert the pom pom prong with ribbon into
either opening of the top seam. Push prong
through until the ribbon can be pulled out.
Using the same piece of ribbon repeat
step 6 on the opposite side of top seam.
2
TIP: Add a pom pom
(pg. 8-9)

HAIR CLIP HOLDER
14
Prepare the pieces you will need.
Thread style string and sew ribbon at the
top and bottom of the felt.
Cut two pieces of ribbon,
the length of the felt.
Following the paper pattern instructions,
spot stitch the glitter fabric to felt and
trim style string. Scrunch the long edge
of glitter fabric and sew from (1) to (2),
where indicated.
Pop out the two hair clip holder paper patterns. Trace the
shorter pattern onto felt, and cut. Using the longer pattern,
trace and cut two pieces of glitter fabric.
12
5
4
3

HAIR CLIP HOLDER
15
3
Hair Clip
Holder
PROJECT
TIP: Add a pom pom (pg. 8–9) and
a gathered bow for extra style!
To create handle, sew ribbon on
top left and right corners.
6
TIP: Customize with
decorative pieces!
Check Out
@coolmaker
for How-To Videos!

SCRUNCHIE
16
Prepare the pieces you will need.
Cut a piece of style string 3” / 7.6 cm
longer than the pre-cut stretch fabric.
Thread the machine with style string and
sew rest of the seam.
Spot stitch the end of the style string to
the side seam.
Pull the long string until fabric
bunches and flip inside out.
Fold the fabric lengthwise with the style
string inside along the fold.
1
46
5
PROJECT
Scrunchie
2
3
4

17
TROUBLESHOOTING
Push elastic through and tie the ends together.
Insert one end
of fabric into
the other end
and sew. Do not
sew through
elastic.
CAUTION: Never use more than 2 layers of felt fabric at a time. Machine can jam.
PROBLEMS: SOLUTIONS:
1
Machine Goes On Stand By Mode Turn machine OFF/ON.
2
Flickering Lights 1. Batteries may be low and require changing.
2. Fabric may be jammed. See trouble shooting for Fabric Jams.
3
Loose Seams Stitch over weak spots once more to strengthen seam. The slower
you push the fabric through, the stronger the seam will be.
4
Fabric Jams 1. Turn machine OFF/ON - needles will reset to default position. OR
2. Turn machine OFF. Push in and turn the manual knob until the
needles are cleared of the fabric and Style String. Remove the
fabric and restart the machine.
78

TM & © Spin Master Ltd. All rights reserved. Remove all packaging before use. Retain
this information, addresses and phone numbers for future reference. Content may
vary from pictures. An adult should periodically check this toy to ensure no damage or
hazards exist, if so, remove from use. Children should be supervised during play. Meets
CPSC Safety Requirements. Spin Master Ltd. reserves the right to discontinue use of the
www.coolmaker.com website at any time.
The YouTube logo and YouTube icon are trademarks of Google Inc. The Instagram Glyph
logo is a trademark of Instagram, LLC in the United States and elsewhere.
SPIN MASTER LTD., 450 FRONT STREET WEST, TORONTO, ON M5V 1B6 CANADA
Imported into EU by SPIN MASTER INTERNATIONAL, S.A.R.L., 20 RUE DES
PEUPLIERS, L-2328, LUXEMBOURG
MADE IN CHINA
(T56013_0003_20088604_GEN_IS_R2)
Be a Cool Maker™!
www.coolmaker.com
DETATCH FOR REFERENCE
aWARNING: CHOKING HAZARD – Small parts.
aWARNING: STRANGULATION HAZARD - Long cord.

18
DETATCH FOR REFERENCE
DIAGRAM
Diagram:
Manual Knob
Style String
Guide
Style String Guide
Seam Guide
Fold Guide
Pom Pom Maker
Attachment
ON/OFF Switch
Start/Stop Button
Storage Drawer
*Requires 4 AA
(LR6) Batteries
Not Included.
Needle Guard
Light

Sew it
with the SEW N’ STYLE MACHINE!
Shape it
with the POTTERY STUDIO!
Style it
with the AIRBRUSH STYLING STUDIO!
Each sold separately.
Be a Cool Maker!™
™
www.coolmaker.
@coolmaker
#coolmaker
Be a Cool Maker!™
Follow Us & Share Your Creations!
co m