209880 / 8581616300
2014-10-10·IO00·III·en·03
Application
3
SolConeX Receptacle & Plug 125 A
8581/41 & 8581/22
3 Application
The receptacle 8581/41 and the plug 8581/22 are explosion protected equipment,
certified for use in hazardous (classified) locations.
4 Safety Instructions
The receptacles and plugs must be used only for their intended purpose. Incorrect usage
invalidates our warranty provision.
CAUTION:
Disconnect power supply before installing or servicing these receptacles and/or plugs.
Modifications to this product are not permitted.
Operate only undamaged and clean devices with observations of the operating
parameters in section 6.
For a Class I Zone 1 conduit installation, conduit seals are required,
refer to NFPA 70 (NEC) 505.16 (B) (1) or CEC C22.1. For any cable or
other conduit installation, NO seals are required.
Use only approved wiring methods for the location with the associated
conduit/cable fittings.
The receptacle is suitable for use on a circuit capable of delivering not more than
10,000 rms symmetrical amperes, 600 V maximum, when protected by properly sized
Class J fuses, 200 amperes maximum. Supply wires shall be rated for + 75 °C.
5 Conformity to Standards
The 8581/41 Series of receptacles and the 8581/22 Series of plugs have multiple
certifications printed on the nameplate.
6 Technical Data
Please refer to the technical data on the nameplates.
WARNING
Installation and maintenance of this product should only be performed by skilled
and experienced personnel in accordance with the National Electrical Code
(NFPA 70 - NEC) or the Canadian Electrical Code (CEC), respectively, and
applicable local code regulations.
Explosion protection
NEC Class I, Zone 1&2, AEx d e IIC T5 Gb
Class I, Div. 2, Groups ABCD T5
Class II, Div. 1 & 2, Groups EFG
Class III
Ta = -30 °C (-22 °F) ... +40 °C (+104 °F)
CEC Class I, Zone 1&2, Ex d e IIC T5 Gb
Class I, Div. 2 per CEC J18-150
Class II, Div. 1, Groups G
Ta = -30 °C (-22 °F) ... +40 °C (+104 °F)
IECEx Ex d e IIC T6 (Ta = - 30 ... + 40 °C)
Ex d e IIC T5 (Ta = - 30 ... + 45 °C)
ATEX EII 2 G Ex d e [ib] IIC T6, T5, T4
EII 2 D Ex tD A21 IP66 T60 °C...T105 °C
