Subaru SEDEYA6001 User manual

Welcome
Thank you for choosing this Subaru product which has been carefully
designed and developed to complement the Subaru vehicle model
range.
We recommend that you should read this manual carefully BEFORE
commencing the installation and then keep it for reference in case you
should ever need to remove this device.
IMPORTANT:
Once the product has been installed, it will require a specific
pairing process to match the users phone/s.
Examples of this procedure are shown in the User Manual
provided with this kit but as new phones are constantly entering
the market, please consult the vehicle importer for latest
information.
- 2 -
English

- 3 -
Kit Contents
1
2
3
8
7
6
1. Control unit
2. Command keypad
3. Microphone with fixing kit
4. Installation manual
5. User manual
6. Control unit connection harness
7. Radio mute unit
8. Radio connection harness
English
45
Ref:SEDEYA6001
e2
Ref:SEDEYA6001
e2

- 4 -
English
Wiring diagram
AUTORADIO
VEHICLE WIRING
HARNESS
FUSES x2

- 5 -
Installation instructions:
English
1: Disconnect the battery
Before commencing the installation, disconnect the vehicle battery following normal
vehicle guidelines.
Remove the vehicle radio following the procedures described in the vehicle
workshop manual. Ensure any radio codes etc are noted and any alarm
disconnection procedures are followed.
2: Choose suitable component locations:
2.1: The control unit:
See vehicle specific installation information later in this manual for detailed
locations for the system control unit but observe the following general rules:
- Do not position the unit near source of extreme heat or the air conditioning
unit.
- Protect the unit from exposure to direct sunlight
- Do not enclose the unit in a metallic box as this will adversely effect the
Bluetooth connection.
The control unit can be mounted using several fixing methods:
- Cable ties
- Double sided adhesive tape (The fixings are not provided in the kit)
- Screws
When using screws, be careful when drilling holes and be careful not to
overtighten the screws when fixing the unit.

- 6 -
Installation instructions (cont.)
English
2.2: The microphone:
The microphone should be mounted between the sunvisor and the rear view mirror
and pointed towards the driver.
Remove the adhesive part of the Velcro tape and stick in the chosen location.
Position the microphone on the Velcro tape.
3: Connecting the components:
Once all the components shave been suitably located, they can be connected
together.
3.1: Microphone:
Plug the mini-jack connector of the microphone into the corresponding connector of
the control unit.
3.2: Command keypad:
Connect the command keypad to the corresponding connector on the control unit
wiring harness (Fig.6 on the wiring diagram).
NOTE: Observe label on harness to ensure correct connection.
3.3: Radio connection:
Remove the vehicle wiring harness from the rear of the vehicle radio and
interconnect the radio connection harness (Fig.8 on the wiring diagram) between
the radio and the vehicle harness.
4: Reassembly & Reconnecting the battery:
Once all the components have been connected, tidy up any excess wiring and
secure with cable ties where necessary. Reassemble all the trim panels and
vehicle components and reconnect the battery following normal reconnection
procedures.
Clean any dirty marks from the trim.

5:B9 TRIBECA - 2007>
GB:Specific vehicle information:
F:  Information spécifique au véhicule
D:  Fahrzeug spezifische information
I:  Informazione specifiche del veicolo
DO NOT REMOVE TRIM PANEL
NE PAS ENLEVER LE PANNEAU D'ÉQUILIBRE
ORDNUNG VERKLEIDUNG NICHT ENTFERNEN
NON RIMUOVERE IL PANNELLO DI CORNICE
!