Sunshower DUO WHITE User manual

DUO
WHITE / BLACK
USER MANUAL
P. 3 P. 7 P. 11 P. 15

SERIAL STICKER
You can enjoy a 2 year warranty
on your Sunshower. Receive an
extra 6 months by registering your
Sunshower online at
www.sunshower.nu/product-
registration/
Standaard heeft u 2 jaar garantie op
uw Sunshower. Ontvang 6 maanden
extra garantie door uw Sunshowers
online te registreren op
www.sunshower.nu/nl/service/
productregistratie/
Votre Sunshower a une garantie de
2 ans. Recevez 6 moins de garantie
supplementaire par registrer votre
Sunshowers online sur
www.sunshower.nu/product-
registration/

3
INTRODUCTION
Congratulations on the purchase of your Sunshower DUO, which will enable
you to enjoy deep-acting infrared warmth during your daily shower. The infrared
warmth of the Sunshower penetrates deep into the skin, keeping muscles and
joints supple. The Sunshower DUO can be installed at standing height or for use
over the top of a seat. The Sunshower DUO turns your shower into a functional,
easy-to-use infrared cabin. It’s made from high-quality materials and features a
stylish finish.
Relax, enjoy and experience the Sunshower feeling!
The Sunshower DUO is in compliance with all conditions imposed by national
and European legislation. Follow the instructions provided to guarantee safe
operation of the Sunshower DUO. Keep the operating instructions somewhere
safe, so that you can consult them at a later date if necessary.
INSTALLATION
• PLEASE NOTE: DO NOT OPEN THE SUNSHOWER TO PREVENT RECEIVING
AN ELECTRIC SHOCK. THE INTERIOR CONTAINS NO COMPONENTS WHICH
CAN BE REPAIRED BY THE USER. LEAVE ALL REPAIRS TO AUTHORISED
PERSONEL.
• The electrical installation can only be carried out by a specialised
company, observing the legal guidelines and the national requirements
concerning the installation, for example, in the Netherlands NEN 1010 and
internationally, IEC 60364-7-701.
• The Sunshower DUO has a maximum output of 1500 W. Do not connect up
any other heavy-duty electrical equipment to the same fuse group as your
Sunshower.
• The Sunshower must be connected to a (preferably separate) circuit that is
protected with a 16 A residual current device (RCD).
• Before connecting up the Sunshower DUO, check that the voltage specified
on the Sunshower DUO (230 V) is the same as the mains voltage.
• Make sure that you unscrew the relevant fuse in the fuse box (or deactivate
the main switch) prior to installation and connection.
For a detailed description of the installation process, see the installation
manual supplied with the Sunshower DUO. This is also available from our
website: www.sunshower.nl.
USER MANUAL DUO | P1416 REV C

4
USE OF THE SUNSHOWER
Bear the following in mind when using the Sunshower DUO:
• Remove creams, lipstick and any other cosmetics from your skin well
before starting your infrared session.
• Avoid getting too hot. If necessary, stand or sit a little further away from the
Sunshower.
• Don’t look into the infrared lamp for too long.
• Avoid anyone else looking into the light of the Sunshower during use; their
eyes could be damaged otherwise.
• Keep to the distance specified, so at least 20 cm from the Sunshower.
• Do not touch the glass pane during or shortly after use; it can get hot.
• Do not use the Sunshower DUO if you are sensitive to infrared light; consult
your doctor if in any doubt.
INFRARED AND YOUR HEALTH.
Sunshower uses IR lamps with a full IR spectrum and optimal short wave
radiation. This radiation is able to penetrate deep into the skin (to a depth of
6mm), warming the body effectively and optimally. Harmful substances in the
blood are discharged faster, blood vessels widen and muscles become more
supple and effective. These lamps are most suitable for the treatment of your
neck, back and shoulders for short periods of time. The maximum treatment
time is 10 minutes, because of which the body will not overheat.
STARTING A SESSION
• Make sure that you are standing at a distance of at least 20 cm from the
Sunshower DUO.
• Press the START/STOP button for about 1 second; you will see that the
button lights up white.
• The infrared lamps on modules 1 and 2 will be activated for 10 minutes and
will then stop automatically.
• If you press the START/STOP button during a session, the session will end
immediately.
Once deactivated, the Sunshower DUO will need four minutes to cool down,
after which it can be used again. The START/STOP button will blink white during
the cooling process.
START/STOP
USER MANUAL DUO | P1416 REV C

5
CLEANING AND MAINTENANCE
The outside of the Sunshower is the only part of the product that users should
clean.
• The Sunshower may only be cleaned by hand.
• Never use a high-pressure cleaner to clean the Sunshower.
• Do not clean the Sunshower when it is on.
Use mild detergents to clean the Sunshower. A special maintenance pack is
available too. It consists of a mild cleaner and a protector, which protects the
Sunshower against limescale.
REPLACING THE LAMPS
The infrared lamps in module 1 (1000 W) and module 2 of the Sunshower DUO
(500 W) have a long lifespan of 2,000 hours and will deteriorate very little in
performance during this time. These lamps should only be replaced when they
have stopped working.
GUARANTEE & SERVICE
The Sunshower DUO is supplied with a two-year warranty. This warranty will
be honoured if the Sunshower DUO is installed correctly and you are able
to produce your proof of purchase. Receive six months extra warranty by
registering your Sunshower online on www.sunshower.nl/garantie.
Sunshower is only liable for product and design defects. Please note that
Sunshower cannot be held liable for the consequences of careless use of the
product or for the consequences ensuing from the violation of local regulations.
The warranty does not cover any damage caused to the Sunshower DUO when
the instructions provided in the user manual are not observed. We will not
accept liability for material damage or personal injury that are the result of
incompetent use or failure to observe the safety instructions. The warranty will
not cover any of the situations outlined above.
TROUBLESHOOTING
The Sunshower is not responding
• Press the START/STOP button on module 1 of the Sunshower DUO for about
1 second; the Sunshower will not respond if the button is not pressed in
long enough.
• The Sunshower is still cooling down. The START/STOP button of module 1 of
the Sunshower DUO will blink white during the cooling process.
• Check the meter cupboard to make sure that the fuse has not blown and
that the main switch is ON.
The Sunshower stops working during an infrared session
• The electronics in the Sunshower DUO can be sensitive to dips in the mains
voltage (that last longer than 10 ms), causing the Sunshower DUO to stop
working during an infrared session. Allow the Sunshower to cool down for
10 minutes and then start a new session.
• One of the Sunshower DUO modules has overheated and has cut out
automatically. Check that the ventilation openings are not blocked.
If you are not able to solve the problem yourself, complete the service form on
our website: www.sunshower.nl/service. Alternatively, contact Sunshower via
[phone] or send an e-mail to [e-mail].
USER MANUAL DUO | P1416 REV C