Sunshower SOLO White User manual

SOLO
WHITE / BLACK
INSTALLATION GUIDE
P. 2 P. 15 P. 28 P. 54P. 41

2
SOLO
WHITE / BLACK
ARTICLE NO.
80076 (WHITE)
80066 (BLACK)
INSTALLATION GUIDE

3
INSTALLATION GUIDE SOLO | P1327 REV E
GENERAL INSTRUCTIONS
Sunshower B.V.
Hoogoorddreef 63-65
1101 BB Amsterdam
The Netherlands
T [phone]
www.sunshower.nl
[e-mail]
!
BE SURE TO READ THIS INSTRUCTION CAREFULLY BEFORE
INSTALLATION. INSTALLATION ONLY CAN ONLY BE
CARRIED OUT BY QUALIFIED INSTALLERS. THE ELECTRICAL
CONNECTION OF SUNSHOWER COMPONENTS CAN
ONLY BE CARRIED OUT BY QUALIFIED ELECTRICIANS.
SUNSHOWER IS NOT LIABLE FOR DAMAGE CAUSED BY
INCORRECT INSTALLATION.
GENERAL
!
THE ELECTRICAL CONNECTION OF SUNSHOWER
COMPONENTS MAY ONLY BE CARRIED OUT BY A
QUALIFIED ELECTRICIAN. THE INSTALLATION AND
ELECTRICAL CONNECTION OF THE SUNSHOWER
INSTALLATION MUST BE CARRIED OUT IN ACCORDANCE
WITH THE APPLICABLE INTERNATIONAL AND NATIONAL
STANDARDS AND GUIDELINES. THE SUNSHOWER MUST
BE PROTECTED BY A SEPARATE EARTH LEAKAGE CIRCUIT
BREAKER (RCD) (SEE ELECTRICAL CONNECTION).
ELECTRICITY

4
INSTALLATION GUIDE SOLO | P1327 REV E
CERTIFICATE OF CONFORMITY
Sunshower B.V., Hoogoorddreef 63-65, 1101 BB Amsterdam, The Netherlands
hereby declares that:
• These Sunshower products are IPX5 approved and specially designed for use
and installation in zone 1.
• The notified body DARE!! Measurements, an ISO17025 accredited institution
for performing product certifications with registration number C447.
• These products are in conformity with the Low-Voltage Directive 2014/35/
EU and the Directive 2014/30/EU for Electromagnetic compatibility of the
European Parliament.
• These products are tested and meet the following norms/directives for CE
markings:
• EN60335-1:2012 + AC:2014 + A11:2014
• EN60335-2-27:2013
• EN61000-6-3:2007 + A1:2011 + AC:2012
• EN61000-6-1:2007
• EN61000-3-3:2013
• EN61000-3-2:2014
The Netherlands, Amsterdam, 1 jan 2019
M. Wegdam, Technical Director
Sunshower B.V.
Hoogoorddreef 63-65
1101 BB Amsterdam
The Netherlands
T [phone]
www.sunshower.nl
[e-mail]

5
NOT INCLUDED
SOLO
CABLE +
BRACKETS +
CONNECTION SLEEVE
INSTALLATION GUIDE SOLO | P1327 REV E
PREPARATION
BOX CONTENT
□Measuring tape
□Screwdriver ( + )
□Spirit level
□Sealant
□Pencil
INSTALLATION
BAG

6
A
B
C
D
E
450 MM
185 MM
1000 MM
1000 MM
520 MM
AB
D
C
E
C
D
E
REQUIRED TOOLS
INSTRUCTIONS
This overview indicates the
relevant dimensions for mounting
the Sunshower.
A bracket height of 52 cm is
suitable for users up to a height of
190 cm.
For taller users, dimension E should
be calculated as follows;
Body height - 125 cm
INSTALLATION GUIDE SOLO | P1327 REV E
PREPARATION
DIMENSIONS
□Measuring tape
□Pencil

7
A
19 MMA
1
2
INSTRUCTIONS
Mount the bottom bracket and the
top bracket using the markings you
made previously when deciding the
Sunshower’s height.
Check that the underside of the
bracket is level and attach both
brackets using the plugs and screws
provided. The upper bracket can be
mounted on either the right-hand
or left-hand wall. After assembly,
screw the nut into the bracket as
shown in (2).
To prevent moisture problems in
the wall, apply sealant between the
brackets and the wall.
INSTALLATION GUIDE SOLO | P1327 REV E
INSTALLATION
FIT BRACKETS
REQUIRED TOOLS
□Spirit level
□Sealant
□Screwdriver( + )
□Plugs
□Screws
5x
5x

8
A
B
INSTRUCTIONS
This manual shows two options for
connecting the Sunshower:
Routing the cable through the
wall to which the Sunshower is
mounted.
Routing the cable from the top
to the Sunshower via a cable
duct.
In all cases, you must use a YMVK
cable with a maximum diameter of
10 mm. The Sunshower is supplied
with 4 metres of cable.
Refer to the table below for the
two different connection methods.
INSTALLATION GUIDE SOLO | P1327 REV E
INSTALLATION
ELECTRICAL CONNECTION
A
B
PAGE 9
PAGE 10
A
B

9
A
B
B
40 MM
1000 MM
A
B
INSTRUCTIONS
You can achieve the best finish by
feeding the fixed wiring through a
hole in the wall.
When using this method, you
can run a connecting cable from
outside the shower cubicle or
use the cable supplied with the
Sunshower.
Drill a 10 mm hole in the wall at
the height shown. You can choose
the right-hand or left-hand wall.
Feed the cable through the hole
and seal it carefully to ensure a
watertight seal.
Allow at least 60 cm of cable from
the wall to the Sunshower.
INSTALLATION GUIDE SOLO | P1327 REV E
INSTALLATION
FEED CABLE THROUGH
REQUIRED TOOLS
□Sealant
A

10
A
A
1000 MMA
INSTRUCTIONS
When using this method, you
can run a connecting cable from
outside the shower cubicle or
use the cable supplied with the
Sunshower.
Attach the cable duct on/in the
wall and feed the cable through it.
Make sure that the cable duct is
not trapped between the wall and
the Sunshower.
Allow at least 60 cm of cable from
the wall to the Sunshower.
INSTALLATION GUIDE SOLO | P1327 REV E
INSTALLATION
CABLE DUCT
REQUIRED TOOLS
□Cable duct
B

11
2
1
INSTALLATION
SUNSHOWER PLACEMENT
INSTRUCTIONS
Place the Sunshower on the lower
bracket (1). Make sure that the pins
engage in the openings in the lower
bracket.
Hook the cord securely into the
groove in the upper bracket (2).
INSTALLATION GUIDE SOLO | P1327 REV E

12
1
2
INSTRUCTIONS
Connect the cable you have run to
the Sunshower cable. Depending
on the situation, you can connect
the cables using a cable gland
behind the Sunshower (1), or using
a cable gland outside the shower
(2).
In both cases, make sure that 60
cm of cable remains between the
Sunshower and the wall, so that it
can be connected correctly.
INSTALLATION GUIDE SOLO | P1327 REV E
INSTALLATION
ELECTRICAL CONNECTION
OR

13
2
1
3
INSTALLATION
SUNSHOWER PLACEMENT
INSTRUCTIONS
Carefully push the Sunshower
towards the wall (1) and tighten
the bolt when the Sunshower’s
bracket has slid underneath (2)(3).
INSTALLATION GUIDE SOLO | P1327 REV E
REQUIRED TOOLS
□Screwdriver ( + )

14
INSTRUCTIONS
Switch on the circuit or residual
current circuit breaker.
The on/off button on the
Sunshower will flash briefly (do
not touch the on/off button
when it flashes; the Sunshower is
calibrating).
If the power button does not
flash, check that the connector is
correctly fitted.
Test whether the Sunshower
operates correctly by turning it
on with the on/off button. Press
the on/off button again to turn off
the Sunshower. The Sunshower
will cool down for another four
minutes.
The Sunshower is ready for use!
INSTALLATION GUIDE SOLO | P1327 REV E
INSTALLATION
FINISH INSTALLATION

15
SOLO
WHITE / BLACK
ARTIKELNR.
80076 (WIT)
80066 (ZWART)
INSTALLATIEHANDLEIDING

16
Sunshower B.V.
Hoogoorddreef 63-65
1101 BB Amsterdam
Nederland
T [phone]
www.sunshower.nl
[e-mail]
INSTALLATIEHANDLEIDING SOLO | P1327 REV E
ALGEMENE INSTRUCTIES
! !
LEES DEZE INSTRUCTIES ZORGVULDIG DOOR VOORDAT
U MET DE INSTALLATIE BEGINT. INSTALLATIE DIENT
ENKEL UITGEVOERD TE WORDEN DOOR GESCHOOLD EN
ERKEND VAKPERSONEEL. DE ELEKTRISCHE AANSLUITING
VAN SUNSHOWER-COMPONENTEN MAG ALLEEN DOOR
EEN ERKEND ELEKTRICIEN WORDEN UITGEVOERD.
SUNSHOWER IS NIET AANSPRAKELIJK VOOR SCHADE
VEROORZAAKT DOOR ONJUISTE INSTALLATIE.
DE ELEKTRISCHE AANSLUITING VAN SUNSHOWER-
COMPONENTEN MAG ALLEEN DOOR EEN ERKEND
ELEKTRICIEN WORDEN UITGEVOERD. DE MONTAGE
EN ELEKTRISCHE AANSLUITING VAN DE SUNSHOWER-
INSTALLATIE MOET WORDEN UITGEVOERD IN
OVEREENSTEMMING MET DE GELDENDE INTERNATIONALE
EN NATIONALE NORMEN EN RICHTLIJNEN (BIJVOORBEELD
VOOR NEDERLAND: NEN 1010 – 701). DE SUNSHOWER
MOET WORDEN BEVEILIGD DOOR EEN APARTE
AARDLEKSCHAKELAAR (RCD) (ZIE ELEKTRISCHE
AANSLUITING).
ALGEMEEN ELEKTRA

17
CONFORMITEITSVERKLARING
Sunshower B.V., Hoogoorddreef 63-65, 1101 BB Amsterdam, Nederland verklaart
hierbij dat:
• dit Sunshower product IPX5 gekeurd en speciaal ontwikkeld is voor gebruik en
installatie in de douche (zone 1)
• dit product is getest is door DARE!! Measurements: een ISO17025
geaccrediteerd testhuis voor het uitvoeren van productcertificaties onder het
registratie nummer C447
• dit product is gefabriceerd volgens Directive 2014/30/EU van de Europese
Gemeentschap en de Low-Voltage Directive 2014/35/EU van de Europese
Gemeentschap
• dit product is gekeurd en voldoet aan onderstaande normen/richtlijnen voor CE
markering:
• EN60335-1:2012 + AC:2014 + A11:2014
• EN60335-2-27:2013
• EN61000-6-3:2007 + A1:2011 + AC:2012
• EN61000-6-1:2007
• EN61000-3-3:2013
• EN61000-3-2:2014
Nederland, Amsterdam, 1 jan 2019
M. Wegdam, Technisch Directeur
Sunshower B.V.
Hoogoorddreef 63-65
1101 BB Amsterdam
Nederland
T [phone]
www.sunshower.nl
[e-mail]
INSTALLATIEHANDLEIDING SOLO | P1327 REV E

18
NIET MEEGELEVERD
SOLO
KABEL +
BEUGELS +
AANSLUITMOF
INSTALLATIEHANDLEIDING SOLO | P1327 REV E
VOORBEREIDING
ONDERDELEN DOOS
□Rolmaat
□Schroevendraaier ( + )
□Waterpas
□Kit
□Potlood
MONTAGEZAKJE

19
A
B
C
D
E
450 MM
185 MM
1000 MM
1000 MM
520 MM
AB
D
C
E
C
D
E
BENODIGDHEDEN
INSTRUCTIES
In dit overzicht vindt u de
belangrijkste maten voor het
monteren van de Sunshower.
Voor gebruikers met een
lengte tot 190 cm kan een
onderbeugelhoogte van 52 cm
worden gehanteerd.
Voor lengtes daarboven wordt het
volgende geadviseerd voor maat E;
lichaamslengte - 125 cm
INSTALLATIEHANDLEIDING SOLO | P1327 REV E
VOORBEREIDING
BEMATING
□Rolmaat
□Potlood

20
A
19 MMA
1
2
INSTRUCTIES
Monteer de onderbeugel en
de bovenbeugel met behulp
van de markeringen die u heeft
aangebracht aan de hand van de
hoogtebepaling van de Sunshower.
Controleer of de onderbeugel
waterpas hangt en monteer beide
beugels met de bijgeleverde
pluggen en schroeven. De
bovenbeugel kan zowel op de
rechter- als linkermuur worden
gemonteerd. Schroef na de
montage de moer in de beugel
zoals weergegeven bij (2).
Om vochtproblemen in de muur te
voorkomen is het raadzaam om kit
tussen de beugels en de muur aan
te brengen.
INSTALLATIEHANDLEIDING SOLO | P1327 REV E
INSTALLATIE
MONTEREN BEUGELS
BENODIGDHEDEN
□Waterpas
□Kitspuit
□Schroevendraaier ( + )
□Pluggen
□Schroeven
5x
5x