superbrightleds FLCKM2 Series User manual

Knuckle-Mount LED Flood Light Fixture
Important: Read all instructions prior to installation. FLCKM2 Series
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 09/28/2022
Specications
Safety and Notes
Operating Temperature -40°–113° F (-40°–45° C)
Environmental Rating IP65
Specications FLCKM2
• Product should be installed and serviced in accordance with
applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power
source and circuit breakers are switched o󰀨 before performing
any installation or wiring procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the
weight of the xture. Failure to properly support xture may result
in damage or injury, for which the manufacturer does not
assume responsibility. FLCKM2-SW3B30-BRK
Wiring Diagram
CCT / Wattage / Photocell Settings
User Manual
5yr
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Gray/Pink
Green
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Gray/Pink
Green
120–277 VAC Input
0–10 V Dimming
CCT Selection
Photocell On/Off
40W 50W 60W
3K 4K 5K
SENSOR
ON OFF
Wattage Selection
(60 W only)
Use a screwdriver to remove plug.
Make desired CCT, wattage (60 W only),
and photocell adjustments.

Knuckle-Mount LED Flood Light Fixture
Important: Read all instructions prior to installation. FLCKM2 Series
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 09/28/2022
Installation Instructions
1. If mounting to junction box, begin by removing junction box cover.
2. Remove lock nut and thread light into base or attach to junction box using lock
nut to secure in place.
3. With supply power turned o󰀨, connect wiring.
4. Attach base to surface or replace junction box cover depending on type of
installation.
5. Loosen knuckle and adjust light to desired angle.
User Manual
5yr