superbrightleds WPGL Series User manual

LED Wall Pack with Glass Lens
Important: Read all instructions prior to installation. WPGL Series
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 11/09/2020
5yr
User Manual
Specications
Safety and NotesWiring Diagram
Opening Fixture
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Gray
Green
Line
Neutral
Ground
Black
L L
N N
GND GND
White
Dim (+)
Dim (-)
Purple
+ +
- -
Gray
Green
• Product should be installed and serviced by a certied electrician in accordance
with applicable national, state, and local building and electrical codes.
• To reduce the risk of electric shock, ensure that the main power source and circuit
breakers are switched o󰀨 before performing any installation or wiring procedures.
• Avoid looking directly into lamp when illuminated.
• Ensure all mounts are securely attached and will support the weight of the xture.
Failure to properly support xture may result in damage or injury, for which the
manufacturer does not assume responsibility.
• Photocell sensor can be disabled by rewiring the light to bypass the sensor on
photocell equipped models.
Model WPGL Series
Operating Temperature -40°–113° F(-40°–45° C)
IP Rating IP65
Dimming 0–10 V
Photocell Operation (HPC models only) Light will turn on when the ambient light level falls below 15 lx
and will turn o󰀨 when the ambient light level exceeds 60 lx.
WPGL-xK60-H
Check product label for specific electrical
specifications related to installation.
Improper installation will void warranty.
Board
Mounting Plate
Board
Mounting Plate
120–277 VAC Input
0–10 V Dimming
The xture can be opened to bypass photocell if needed (where applicable)
or to use conduit wiring through one of the pipe plugs on the side of the unit.

LED Wall Pack with Glass Lens
Important: Read all instructions prior to installation. WPGL Series
4400 Earth City Expy, St. Louis, MO 63045 866-590-3533 superbrightleds.com
Rev Date: V1 11/09/2020
5yr
User Manual
Wall/Junction Box Installation
Conduit Installation
1. Mount rear mounting bracket to surface.
2. With supply power o󰀨, connect wiring.
3. Slide housing over bracket to hang and secure
with set screws at the bottom of the xture.
Note: Apply a bead of silicone where the housing
meets the mounting surface to avoid potential
moisture intrusion.
1. Mount rear mounting bracket to surface.
2. Remove screws and remove front cover.
3. Pull wiring from inside to pull it back through
strain relief in rear of housing.
Note: After pulling wiring through, the hole
in the rear housing should be sealed with
silicone to prevent water intrusion.
4. Slide housing over bracket to hang and secure
with set screws at the bottom of the xture.
Note: Apply a bead of silicone where the housing
meets the mounting surface to avoid potential
moisture intrusion.
5. Remove plug for conduit/wiring.
6. With supply power o󰀨, connect wiring.
Board
Mounting Plate
Board
Mounting Plate
Board
Mounting Plate
Board
Mounting Plate