superbrightleds HLV8 Series User manual

User Manual
HLV8 Series
Rev Date: V0.1 08/09/2022 Rev Date: V0.1 08/09/2022
A 2-year warranty is given from the date of purchase to the original purchaser. The
warranty is for replacement and covers manufacturing faults only. Labor costs are
not covered by warranty. Any damage caused from improper installation, physical
damage, or connecting to voltages other than 12–24 VDC will not be covered.
Warranty
Safety and Notes
• Product should be installed by a qualied technician where possible.
• LED headlight replacements are only water-resistant when used in an enclosed
headlight housing assembly. Do not expose the chip side of the light to water
directly or submerse the bulbs.
• Adequate ventilation is necessary for good heat dissipation, which will prolong
the lifespan of the bulbs.
• Check voltage of the vehicle to be sure it complies with the operating voltage of
this product (12–24 VDC).
• Ensure all wire connections and polarities are correct before applying power to
avoid damage to the bulbs.
• If a fault occurs, contact Super Bright LEDs to initiate a return. Do not attempt to
repair this product by yourself.

Rev Date: V0.1 08/09/2022 Rev Date: V0.1 08/09/2022
Installation
1. Remove the old light bulb from the headlight housing.
2. For models with a removable collar (e.g. H4s), remove the collar
from the light (no tools required) and mount the collar in the headlight
housing.
3. Install LED lamp in correct direction.
Note: Lighting pattern is adjustable by rotating lamp body on removable
collar models only.
4. Connect plug to wiring harness.
5. If clearance allows, reinstall dust cap on rear of headlight housing if
applicable.