superbrightleds HLV5 Series User manual

LED Headlight Kit
Important: Read all instructions prior to installation.
User Manual
Part Number:
LED Headlight Kit
Installation Manual
HLV5 Series
Rev Date: V1 04/14/2017Rev Date: V1 04/14/2017
Installation Instructions
H8 / H11 / H13 / P13W / 9004 / 9005 / 9006 / 9007 / 9012 / PSX26W / P13W / 880 / 881
HLV5 Series
WATERPROOF
67IP
Installation Instructions H16 / PSX24W
Insert the lamp body until clips
engage (as shown).
Secure driver using included wire ties
and double sided tape.
Connect bulb to original
connector.
Insert lamp body as shown being
sure to align locking ring tabs.
Secure using included zip ties
and double sided tape.
Connect bulb to original connector
To adjust beam pattern,
remove allen screw on
locking ring. Rotate bulb
body to desired position.
Reinstall allen. Ensure LEDs
are positioned as in FIG1.
Rotate lamp body until it stops.

HLV5 Series
User Manual
Part Number:
Apply Color Filters (Optional)
Installation Instructions 9004/9007
Installation Instructions H1 / H3 / H4 / H7*
LED Headlight Kit
Important: Read all instructions prior to installation.
Rev Date: V1 04/14/2017
Included
Safety and Notes
1. Product shall be installed and serviced by a qualied technician.
2. LED headlight replacements are waterproof when used in an approved headlight
housing assembly.
3. Good heat dissipation will prolong the working life of the driver, ensure good ventilation.
4. Check voltage of the vehicle to be sure it complies with working voltage of the product.
(9~32 VDC)
5. Ensure all wire connections and polarities are correct before applying power to avoid
any damages to the LED lights.
6. If a fault occurs, return product to Super Bright LEDs. Do not attempt to repair this
product by yourself.
1 - Amber Filters (4 per sheet)
1 - Cool White Filters (4 per sheet)
2 - Allen Wrench (1.3mm or 2mm depending on model)
MAKE SURE LEDS ARE SHINNING HORIZONTALLY WHEN INSTALLED
FIG. 1
POWER CONNECTOR
HEAT SINK
LAMP BODY
TOP CAP
LOCKING RING
Remove existing headlight dust cover, retaining ring/clip and stock bulb.
Remove the locking ring. Insert locking ring and secure with
retaining ring/clip.
Secure driver using included zip ties
and double sided tape.
Connect bulb to original
connector. Lighting pattern is adjustable
Insert the lamp body as shown.
Ensure positon of lamp body and
align with slots in locking ring.(Fig1)
1. Remove top cap.
2. Slide O-ring and glass over
lamp body.
3. Reinstall top cap being careful
not to over tighten.
4. Remove Filter from sheet and
wrap around glass.
*H7 bulbs may require an additional adapter/retainer on some Buick, BMW, Ford, Kia,
Mercedes, Nissan, and VW/Audi models. Check your vehicle before ordering.
2 - 3M Double Sided Tape
4 - Zip Ties
Flange
Retainer*
(not included)
1. Remove hex key screw holding mounting ange to bulb, then slide ange o󰀨 of bulb.
2. Align three ears on original retainer with three notches on ange and slide.
3. Re-insert bulb into ange then reinstall hex key screw.
4. Install bulb into headlight housing and rotate to adjust beam angle. Lock retainer in
place when desired angle is achieved.
*Note: Some Ford models may require the retainer to be trimmed to clear heat sink on bulb.