Symmons Duro 362SH Manual

1Symmons Industries, Inc. ■31 Brooks Drive ■Braintree, MA 02184 ■[phone] ■ Fax: [phone]
©2014 Symmons Industries, Inc. ■ www.symmons.com ■ [email protected] ■ ZV-3019 REV 0 01/15/2014
361SH, 362SH
Duro™Showerhead Series
Operation & Maintenance Manual
Model Numbers Specifications
361SH Duro 4" 1 Mode Showerhead
362SH Duro 3" 1 Mode Showerhead
4" 1 mode showerhead (361SH) and 3" 1 mode
showerhead (362SH) include standard 2.5 gpm
(9.5 L/min) ow restrictor. Components made from metal
and plastic materials plated in standard polished chrome
nish.
Modifications Compliance
-1.5 1.5 gpm (5.7 L/min) flow restrictor
-2.0 2.0 gpm (7.6 L/min) flow restrictor
-STN Satin nickel finish
Note: Append appropriate -sufx to model number.
-ASME A112.18.1/CSA B125.1
-WaterSense (1.5 & 2.0 gpm for 362SH only)
Warranty
Limited Lifetime - to the original end purchaser in
consumer installations.
5 Years - for commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
Dimensions
AA
B
B
D
D
C
C
361SH
362SH
Note: Dimensions are subject to change without notice.
Measurements
A 3”, 76 mm
B 3 3/8”, 86 mm
C 3 1/2”, 89 mm
D 3 1/2”, 89 mm
Required for Installation
Teon Tape
Certied by
IAPMO R&T
c

2Symmons Industries, Inc. ■31 Brooks Drive ■Braintree, MA 02184 ■[phone] ■ Fax: [phone]
©2014 Symmons Industries, Inc. ■ www.symmons.com ■ [email protected] ■ ZV-3019 REV 0 01/15/2014
1) Install showerhead to shower arm
(not included) turning clockwise
to tighten.
361SH, 362SH
Duro™Showerhead
Operation & Maintenance Manual
Installation
1
2
Care and Cleaning
1) Clean nished trim area with a soft cloth using mild soap and water or a non-abrasive cleaner and then quickly rinse
with water.
Troubleshooting Chart
Problem Cause Solution
Finish is spotting. Elements in water supply may cause
water staining on nish.
Clean nished trim area with a soft
cloth using mild soap and water or a
non-abrasive cleaner and then
quickly rinse with water.
Showerhead is leaking from shower
arm when valve is in “on”
position.
Coupling connecting showerhead
to shower arm is cracked or washer
inside coupling is worn.
Inspect coupling and washer
and replace showerhead if
necessary.