6| Installation and configuration GB
• Wi-Fi connection setup using a mobile application. See 2.4 Wi-Fi connection setup us-
ing a mobile application, page 7.
If wired connection is not an option and a home router does not support WPS function
and control panel is not available.
2.1 Connection to Internet with Ethernet cable
1 Plug one end of the Ethernet cable to
the RJ45 socket on IAM and the other
end to any free Ethernet socket on your
router.
2 The internet access module will auto-
matically try to establish connection to
the router and SAVE Touch Cloud. When
connection is successful, green LED on
the internet access module will start
blinking slowly.
Note:
Green LED blinking twice per second indicates failure to connect to the Cloud
server. Check the Ethernet cable or Internet connection.
Proceed to chapter 5 First Login to Homesolutions by Systemair for login
instructions.
2.2 Wireless connection using WPS function
1 Start WPS (Wi-Fi Protected Setup) on your wireless
router (see your router manual for WPS activation).
Make sure your wireless router supports WPS function.
If you router does not support WPS function, see chap-
ter for detailed information how to set up Wi–Fi con-
nection using control panel.
2 Once WPS is activated, press and hold activation button
(pos. 2) on the internet access module for 5 seconds
until the red LED starts blinking twice per second and
then release activation button.
3 When internet access module successfully connects to
the router (should not take longer than 1 minute), LED
on the internet access module will start blinking once
per second in green colour.
If LED continues to blink fast in red colour, it means Wi-
Fi connection was not established. Reset IAM to default
settings and try again.
See chapter 3 Resetting to default settings, page 8.
4 Once the internet access module is connected to the
wireless router, it will automatically establish connec-
tion with the SAVE Touch Cloud (it should not take
254977 | v05
