2| Installation and configuration
If wired connection is not an option and a home router does not support WPS function.
• Wi-Fi connection setup using a mobile application. See 2.4 Wi-Fi connection setup us-
ing a mobile application, page 3.
If wired connection is not an option and a home router does not support WPS function
and control panel is not available.
2.1 Connection to Internet with Ethernet cable
1 Plug the Ethernet cable to the SAVE
CONNECT module and the other end to
the cable to any free Ethernet socket on
your router.
2 The SAVE CONNECT module will auto-
matically try to establish connection to
the Cloud server. When connection is
successful, green LED on the SAVE CON-
NECT module will start blinking slow.
Note:
Green LED blinking twice per second indicates failure to connect to the Cloud
server. Check the Ethernet cable or Internet connection.
Proceed to chapter 5 First login to SAVE CONNECT application for login
instructions.
2.2 Wireless connection using WPS function
1 Start WPS (Wi-Fi Protected Setup) on your wireless
router (see your router manual for WPS activation).
Make sure your wireless router supports WPS function.
If your router does not support WPS function, see chap-
ter 2.3 Wi-Fi connection setup using a control panel,
page 3 for detailed information how to set up Wi–Fi
connection using control panel.
2 Once WPS is activated, press and hold
activation button (pos. 2) on the SAVE
CONNECT module for 5 seconds until the
red LED starts blinking twice per second
and then release activation button.
3 When the SAVE CONNECT module suc-
cessfully connects to the router (should
not take longer than 1 minute), LED on
the SAVE CONNECT module will start
blinking once per second in green
colour.
If LED continues to blink fast in red col-
our, it means Wi-Fi connection was not
254977 | v6
