Takstar TS-8807 User manual

TS-8807
TS-8807
User's Manual
UHF Wireless Microphones
GUANGDONG TAKSTAR ELECTRONIC CO., LTD.
Address: Xialiao Longxi Boluo Huizhou Guangdong China 516100
Tel: [phone]
Fax:[phone]
Website: www.takstar.com

Security:
4
• Do not apply any strong shock to it.
• Please place the batteries according to correct polarities. Take
out the batteries when not using it for a long time.
Annoucement:
• is a protected and registered trademark
• Product and contents described in the user manual are subject
to change without prior notice
1
Handheld Microphone:
1234
(1) Wire-mesh cap and capsule:
wire-mesh cap protects the
capsule, eliminates “pop”
noise and avoids rolling
when laid flat.
(2) LCD display: indicate
frequency/channel and
battery power level.
(3) Power switch: press once,
it is on; press again, it is off.
(4) Microphone housing:
assemble wire-mesh capsule
and capsule on the top, with
batteries, PCB board inside,
and antenna at the rear.
Specification:
Transmitter
Power Supply: 2pcs 1.5V AA batteries
Playtime: 10hrs(depending on batteries)
Operating Range: 50m(depending on environment)
Operating Temperature: -20° -60°
Output Type: Independent Balanced and Unbalanced Outputs

3
2
Trouble Shooting:
Troules Possible reasons
No RF signal on receiver
Frequency of transmitter and
receiver is not the same or out
of operating range
With RF signal, but no audio
signal
Microphone is not connected or
squelch level of receiver is too high
Background noise of audio
signal is too loud
Frequency deviation is too low;
output level of receiver is too low;
check if there is an interfering signal
Audio signal distortion Frequency deviation is too high;
output level of receiver is too high
Operating distance is too
short, signal is not stable
Transmitter is set at low power;
squelch level of receiver is too
high; receiver antenna is wrong
placed; there is a strong
electro-magnetic interference
If there are other troubles, please contact us or your local
distributor or retailer. Please do not dismantle the products
as it will void warranty.
678
(6) Infra-red data
synchronization window:
send frequency signal
to transmitters by pressing
“SET” on receiver.
(7) Lock switch: if it is set at
“ON” position, the power
switch is locked and can
only be used for mute
function.
(8) Power adjusting switch:
choose high or low transmit
power.
5
(5) Battery compartment: put in
2pcs AA batteries.
1.How to use handheld microphone:
(1) Hold the middle part of microphone. If the hand is too close
to the wire mesh, the sound will be influenced; if the hand
is too close to the antenna at bottom, the operating distance
will be shortened.
(2) By changing the distance between microphone head and
mouth, the sound volume will be increased or reduced.

FCC WARNING
This device complies with Part 74 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE 1: The manufacturer is not responsible for any changes or modifications not expressly
approved by the manufacturer for compliance, such modifications could void the user’s authority
to operate the equipment.
NOTE 2: This device complied with FCC radiation exposure limits as set forth for an uscontrolled
environment. This device should be installed and operated so that its antenna(s) are not co-located
or operating in conjunction with any other antenna or transmitter