EN
6
• N v r put your fing rs or any oth r obj ct in th fill r tub (B) whil th applianc is in op ration.
Always us th push r (A) provid d for this purpos .
• N v r op n th cov r (C) b for th si v (D) has com to a compl t stop.
• Do not r mov th pulp coll ctor (G) whil th applianc is in us .
• Always unplug th applianc from th mains aft r us .
• Wh n you us th applianc for pr parations with hard ingr di nts (for xampl , sugarcan ),
you must not run it for mor than 20 s conds cons cutiv ly.
• This applianc is fitt d with a saf ty m chanism. To start th juic machin , th cov r (C) must
b prop rly s cur d by th saf ty clamp (H). Op ning th saf ty clamp (H) will stop th juic
machin . At th nd of a cycl , plac th control switch (I) to 0 and wait until th si v (D) stops
compl t ly b for r moving th cov r.
• W r comm nd that you wash all th r movabl parts (A, B,C, D, E, G, L, M) in warm soapy
wat r (s paragraph ”Cl aning”). Rins and dry th m car fully.
• Unpack th applianc and plac it on a solid, stabl work surfac .
• Ensur that all packaging has b n r mov d b for starting th applianc .
• Plac th juic coll ctor (E) on th body of th applianc (see Fig. ).
• Plac th si v (D) in th juic coll ctor (E). Ensur that th si v is prop rly clipp d onto th
driv shaft (J). You can h ar an audibl click wh n th si v is position d corr ctly (see Fig. 2).
• Fit th pulp coll ctor (G) on th r ar of th applianc (see Fig. 3).
• Fit th cov r (C) on th applianc , spout to th r ar (see Fig. 4).
• Push th saf ty clamp (H) to th r ar until it locks into plac . You will h ar an audibl “click” (see
Fig. 5).
• Slid th push r (A) into th f d tub (B) aligning th groov on th push r with th small ridg
in th f d tub .
• Th juic jug cov r (L) has a foam s parator that k ps th foam in th jug (M) wh n you pour
th juic into a glass. If you do not want to s parat th foam, r mov th cov r.
• Plac th juic jug (M) und r th pouring spout in front of th applianc (see Fig. 6).
• Plug in th applianc .
• To start th applianc , us th control switch (I).
• Ins rt th fruits or v g tabl s through th f d tub (B).
• Th fruits and v g tabl s must b ins rt d only whil th motor is running.
• Do not pr ss too hard on th push r (A). Do not us any oth r ut nsil. NEVER push with your
fing rs.
• Wh n you hav finish d, stop th applianc by turning th control switch (I) to 0 and wait until
th si v (D) stops compl t ly.
• Wh n th pulp coll ctor (G) is full, or th juic flow slows down, mpty th pulp coll ctor and
cl an th si v and th cov r.
SAFETY SYSTEM
BEFORE FIRST USE
USING THE APPLIANCE
