Teknion Amicus Owner's manual

SEAT HEIGHT ADJUSTMENT SEAT DEPTH ADJUSTMENT
LUMBAR HEIGHT ADJUSTMENT BACK TILT LOCK ADJUSTMENT
TILT TENSION ADJUSTMENT ARM WIDTH ADJUSTMENT
o adjust the angle of reclination,
pull the lever up to unlock the back
and leave the chair in free-flow
mode. Recline to the desired
position and push the lever down
to lock the back in place.
o adjust the lumbar height, grasp
both levers and slide them up or down
to the desired position. Not available
on Amicus General Use Chairs.
o adjust the seat depth, push the
lever down and simultaneously lift
your weight from the seat while
sliding the seat forward or
backward. Release the lever to lock
the seat in place. Not available on
Amicus General Use Chairs.
o raise the chair, lift the lever up
while lifting your weight from the
seat until you reach the desired level,
then release to lock in place. o
lower the chair, lift the lever up and
allow your weight to push the seat
down until you reach the desired
level, then release to lock in place.
Leaning back, determine if the
resistance of the chair is
comfortable. For less resistance, pull
tension adjustment lever out and
turn it counterclockwise. For greater
resistance, turn the lever clockwise.
o adjust the width of each arm,
push the lever down to release the
arm lock. Slide the arm inward or
outward to the desired position.
Push the lever up to lock the arm
in place.
amicus adjustment features & instructions

W rning
ipping or collapsing can result in serious injury. o prevent product failure and possible injury:
• his chair has been designed and tested for users weighing up to 300 lbs
• Frequently inspect the chair for visible cracks and damages, tighten all screws, bolts, adjustable knobs and parts
• Do not use the chair if damaged or unstable – immediately remove it from service
• his chair is equipped with casters intended for use on carpeted surfaces. Use of these casters on hard surfaces could result in unexpected rolling
and tipping. Casters designed for use on hard surfaces are available. If in doubt, see your dealer for appropriate selection
• Do not stand on or use the chair as a step ladder
• Failure to follow these warnings could result in serious injury
2D ARM HEIGHT ADJUSTMENT 3D ARM ADJUSTMENT
3D ARM PIVOT ADJUSTMENT
o pivot the arm cap, grasp and
rotate inward or outward to the
desired position.
o adjust the arm height, press the
top half of the button in and raise
or lower it to the desired position.
Release the button to lock in place.
o adjust the arm height, lift the
button under the arm cap to raise
or lower it to the desired position.
Release the button to lock in place.
amicus adjustment features & instructions