Texecom AED-0009 User manual

Technical Support : 91520 10269 : [e-mail]
Press 1234 on the control panel. The below message will be displayed.
Premier Elite Impaq Plus with Contact
(AED-0009)
Note: In this case we’re connecting sensor in
Zone 001 for reed(Magnetic Contact).
Zone 002 for alarm(Vibration sensors).
Zone 003 for tamper
Hardware Connection:
Reed
Tamper
Alarm
OV
12V
Reed
Tamper
Alarm
OV
12V
Sensor Control Panel
Z1
Z2
Z3
Expander
Sensor
A -
U
X +
A
T
A
T
A
T
Press Yes
Press NO ( X ) to edit the option & Press 3 to change the zone type
A -
U 12V
X +
Control Panel Expander
Programming:
Step 1: Note: If you want to enable and use:
1. Magnetic Contact –Follow Step 1
2. Vibration sensors –Follow Step 2
3. Tamper –Follow Step 3

Technical Support : 91520 10269 : [email protected]om
Press 002 &Press Yes 3 times to reach zone type
Press up arrow ( ) 2 times & press Yes
Press Yes
Press Yes for 7 times to reach zone wiring
Press NO ( X ) to edit the option
Note: In this case we are connecting sensor in
Zone 001 for reed(Magnetic Contact).
Zone 002 for alarm(Vibration sensors).
Zone 003 for tamper
Press NO ( X ) to edit the option and Press 3
Press Yes
Press Yes for 7 times to reach zone wiring
Press NO ( X ) to edit the option
Step 2:

Technical Support : 91520 10269 : [email protected]om
Press 003 &Press Yes 3 times to reach zone type
Press up arrow ( ) 2 times & Press Yes
Press NO ( X ) to edit the option and Press down arrow ( ) for 13 times to reach
tamper
Press Yes
Press Yes for 7 times to reach zone wiring
Press NO ( X ) to edit the option
Press up arrow ( ) 2 times & Press Yes
Press Menu ( ) two times on the control panel and then press Yes to logoff
from your control panel
Step 3:
Note: In this case we are connecting sensor in
Zone 001 for reed(Magnetic Contact).
Zone 002 for alarm(Vibration sensors).
Zone 003 for tamper