Timago TGR-R KT 618 User manual

1
INSTRUCTIONS FOR USE
Folding commode chair with quick-release
Product code: TGR-R KT 618
1. Characteristics
The commode chair is made of powder coated steel frame. It possesses
height adjustable legs with anti-sliding rubber tips. The chair is
equipped with toilet seat with lid and plastic toilet bucket with lid
which can be taken out easily. The commode chair is easy to assemble
owing to the application of quick-release. The chair can be adjusted to
patient’s needs owing to height adjustment while armrests support
stability and safety use.
The set includes:
•Chair frame
•Front and curved rear frame with quick-release
•Toilet seat with lid
•Toilet bucket with lid
Elements of the commode chair:
a. Rear frame
b. Front frame
c. Toilet bucket
d. Height adjustment – locking pin
e. Anti-sliding tips
2. Application
The commode chair is ancillary equipment which helps the user to
perform hygienic activities. The chair is recommended to people with
dysfunctions and reduced mobility who have problems with unassisted
walking and for those who lost the ability of unassisted sitting down
and standing up. The chair functions as a toilet owing to the toilet

2
bucket located under the seat. The chair facilitates performing
physiological activities and taking care of the user.
3. Assembly
Unfolding
Step 1. Unfold the chair frame. Assemble front frame (b) with the use
of quick-release, and then assemble curved rear frame (a).
Step 2.On bottom rail of the rear frame assemble the toilet seat with
lid until the plastic grips click.
Step 3.In case of using the commode chair as a stand for the toilet
seat, the toilet bucket or a sanitary cover should be assembled to the
steel grips of the container.
Height adjustment
•To adjust the height of the chair, press the metal pin, select
appropriate height of the leg, and then, lock the position of the
legs relative to each other with the locking pin. The legs are
adjustable in 2.5 cm increments.
Note! The pins must be set on the same level in each leg. The legs must
always stay stably on the floor.
Usage
•Lift the toilet lid and remove the bucket lid. After use, cover the
bucket with the lid and lower the toilet lid.
•In case of using the chair as a stand for the toilet seat, use the
sanitary cover.
Note! Remember to empty the toilet bucket after each use.

3
4. Technical data
Overall width
57 cm
Inner width
45 cm
Overall depth 50 cm
Seat height from the
ground
40-54 cm
Overall height from the
ground
66-80 cm
Seat dimensions 34 cm x 37 cm
Chair weight 5.9 kg
Maximum capacity 135 kg
Frame colour white
5. Notes
Timago International Group does not bear responsibility of improper
use of the commode chair, failure to comply safety regulations and
misuse.
6. Maintenance
Carry out regular maintenance of the technical condition of the chair:
•Clean the commode chair regularly using only water and mild
detergents. Dry thoroughly.
•Do not use for cleaning: strong polishing agents and detergents,
abrasive agents bleach, petrol or solvents (it may cause frame
damage, visible defects and in consequence - loss of warranty
rights).
•Empty and disinfect the toilet bucket and the toilet seat after each
use. Use toilet cleaning agents according to producer’s
instructions.

4
7. Storage and transport conditions
Device should not be exposed to direct sunlight, water or moisture.
8. Warranty information
All products distributed by our company are covered by a warranty, the
terms of which are described in the warranty card available on our
website. Please contact the retailer from whom you purchased the
product. Please, keep in mind that for warranty purposes, the proof of
purchase (receipt or invoice) should be retained
9. Labels
Reference
number
Manufacturer
LOT number Manufacture date
Serial number Medical device
Note
Please read the
instruction
The manufacturer checked for compliance with
essential medical devices requirements.
Our complete line of products is available from our distributors.
Learn more at: www.timago.com. Thank you for choosing Timago!

5
Timago International Group
Spółka z o.o. i Spółka – Spółka komandytowa
ul. Karpacka 24/12
43-316 Bielsko-Biała, Polska
T.: [phone]
F.: [phone]
E.: [e-mail]
Rev. II, date 20.05.2021