Argos 609/0045 User manual

610/8913
Boston Basic Modular 2 Door
Assembly Instructions -
Please keep for future reference 609/0045
Dimensions
Depth - 30cm
Width - 60cm
Height - 60cm
609/2603
Important - Please read these instructions fully before starting assembly
Version 3 Date: 19/03/15
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800
413/6293
402/9568

1
Safety and Care Advice
Important – Please read these instructions fully before starting assembly
• Check you have all the
components and tools listed on
the following pages.
• Remove all fittings from the
plastic bags and separate them
into their groups.
• Keep children and animals
away from the work area, small
parts could choke if swallowed.
• Make sure you have enough
space to layout the parts before
starting.
• During assembly do not stand
or put weight on the product,
this could cause damage.
• Assemble the item as close
to its final position (in the same
room) as possible.
• Assemble on a soft level
surface to avoid damaging the
unit or your floor.
• Parts of the assembly will be
easier with 2 people.
• To reduce
the likelihood of
damaging your
product please
ensure that your
power drill is set on a low torque
setting.
• Only clean using a damp cloth
and mild detergent, do no use
bleach or abrasive cleaners.
• From time to time check that
there are no loose screws on
this unit.
• This product should not be
discarded with household waste.
Take to your local authority
waste disposal centre.
Care and maintenance
• Assemble all parts and bolts
loosely during assembly, only
once the product is complete
should you fully tighten the bolts
• Regularly check and ensure
that all bolts and fittings are
tightend properly.
Handy Hints

2
Side panel x 2
(56.9 x 29.4cm)
3
Top panel (60 x 29.5cm)
1
Bottom panel (60 x 29.5cm)
2
Left door panel
(28 x 56.3cm)
5
Back panel x 2
(29.5 x 59.6cm)
7
Shelf (56.9 x 27.5cm)
4
Right door panel
(28 x 56.3cm)
6
Pilot holes for guidance only
Pilot holes for
guidance only
Pilot holes for
guidance only
Components - Panels
Please check you have all the panels listed below
If you have damaged or missing components, call the
Customer Helpline:
Argos = 0345 6400800

3
Note: The quantities below are the correct amount to complete the assembly. in some cases mor
may be supplied than are required.
Components - Fittings
I
Shelf support x 4
F
Nail x 16
B
Handle x 2
40mm Screw x 8
E
25mm Screw x 2
A
Metal plate x 2
C
D
Door hinge x 4
G
Door stopper x 1
H
Support cover x 4
12mm Screw x 4
JK
Screw cover x 4
Ruler - Use this ruler to help correctly identify the screws
Tools required
0 5 10 15 20 25 30 35 40 45 50 55 60 65 70 75 80 85 90 95 100 110 115 120 125 130 135 140 145 150 155 160 165 170
105
0 10 20 30 40 50 60 70 80 90 100 110 120 130 140 150
0 1 2 3 4 5 6
Phillips screwdriver
(medium & large)
Small
hammer
Ruler/tape
measure
Drill
Eye protection
(when using a
hammer or glue)
The screws length is measured from the head to the point (30mm screw shown).
7mm Suitable drill bit
(for use with wall plug)

4
Assembly Instructions
Step 1
Bottom panel onto the
Side panels .
E
Attaching side panels
a:
Step 2
a:
Metal plate onto the Left
door panel .
Insert the Door hinges
into the Left door panel .
Attaching door
5
G
Repeat a with remaining
Right door panel .
2
3
C
5
D
6
Continued on next page.
Finished
front edge
1
G
H
Door stopper onto the
Top panel .
G
H
1
Finished
front edge
5
D
D
E
E
E
E
2
3
3
G
C
G
H
G
C
D

5
b:
Assembly Instructions
Step 2 - continued
Step 3 F
Carefully locate the Left
door panel and Right
door panel onto the
the unit aligning the Door
hinges with the corre-
sponding holes.
b:
5
6
Top panel onto the
unit.
E
1
Finished
front edge
5
6
1
E
E
E
E
7
Note: Ensure the Door
hinges are aligned with
the corresponding holes.
back edge
7
back surface
Fixing back panel
Attach Back panels
onto the unit using Nails
.
7
F
Important:
The unit MUST
be ‘square’ when
back is attached.

Step 4
Assembly Instructions
Step 5
6
a:
JI
Attaching door
Attaching shelf
a:
SIide Support covers
onto Shelf supports .
lnsert Shelf supports
(Support covers are
included) into the unit.
before inserting the shelf.
JI
I
Note:
Set the shelf
supports to the desired
height.
J
J+I
Continued on next page.
Handles onto the Left
door panel and Right
door panel .
A
B
5
6
s
handles
5
6
B
A
A
B
B
A

Step 5 - continued
Assembly Instructions
7
b:
c:
b:
Slide the Shelf into
the unit.
4
4
c:
Use Screw covers
to cover the screw heads.
K
Assembly is complete.
Finishing the unit
With help, place the unit in
the intended position.
Note: It would be useful
to ask someone to help
you at the stage.
Step 6
K
K
K
K
K
Finished
front edge
If you need help or have damaged or missing parts, call the Customer Helpline:
Argos = 0345 6400800