
EN - 15
When you are ready with deep-frying you can fully turn back the thermostat knob and remove the plug from the socket.
Once the frying fat has fully cooled down, you can fold the handle of the frying basket to the inside, lower the basket and place
the cover back on the fryer.
Allow the fryer to cool down for a number of hours before moving it. When moving the fryer, always use both hands and always
use the handles on both sides of the fryer.
AFTER DEEP-FRYING
• Cauon: during and aer deep-frying it is possible that drops of condensaon fall in the hot frying fat. The loud noise that
you can hear is the reacon of the liquid to hot frying fat, which is normal. It does not have an eect on the operaon
of your fryer.
• Cauon: when deep-frying sh, meat and dough products, we recommend lowering the empty frying basket in the reservoir
and only then place the products to be fried in the frying basket. This prevents the products from scking to the frying basket.
• To prevent early contaminaon of the frying fat, the products should not be salted prior or during deep-frying.
• For a good result it is recommended to not fully ll the frying basket (maximum 500 grammes). For frozen fries it is
recommended to use smaller porons, as these contain more liquid and could otherwise cool down the frying fat too much.
It is also possible that the frying fat starts to foam violently and could overow.
• When making fresh fries from potatoes, you must properly dry the fries aer washing so that no liquid gets into the frying fat.
TIPS
Turn the thermostat knobs of both heang elements fully to the le, to the OFF posion.
Check that the voltage corresponds with what is stated on the informaon plate.
Check that the handles are properly folded out and switch on the fryer by inserng the plug in the socket.
The red indicator led starts to light up, indicang that the fryer is connected to the power mains.
Turn the thermostat knob of one or both heang elements clockwise to the required temperature. The green thermostat led
starts to light up. The heang element is acvated.
Cauon: always remove the plasc handle of the frying basket from the frying fat before heang up the fryer.
Otherwise the plasc will melt.
Once the required temperature has been reached, the green indicator led switches o. When the temperature drops,
both the thermostat and green indicator led switch on again. The fryer is ready for deep frying.
Fill the frying basket (no more than two thirds) with the products to be fried. Make sure the products to be fried are
suciently dry. Shake deep-freeze products above the sink to remove excess ice. Slowly lower the frying basket in the frying
fat, so that the moisture in the food is able to evaporate. If you do not do this, the frying fat may splash. Always fry without
a cover. This prevents the fryer from overheang and switching o automacally. At the same me, it ensures a more crispy
frying result.
Once the products to be fried are ready, you can li the frying basket, shake it lightly and hang it from the hook to allow the fat
to leak. Serve the dishes and hang the basket back in the fryer.
DEEP-FRYING
The frying basket has been provided with a handle that is easy to store. You can click in the handle and fold it inwards,
so that the fryer can be stored in a properly closed condion. Only fold in the handle once the frying fat has fully cooled
down and do not forget to fold it out again when using it the next me, before heang up!
For the best result you should never use a cover when deep-frying with a cold zone fryer.