Torque HBT100 User manual

TORQUE 100 LB (45.4 KG)
HEAVY BAG
MODEL: HBT100
PART NUMBER: 5591901 REVISION: C
WARNING
SET-UP (A) (THE ATTACHEMENT METHOD IS DEPENDENT ON YOUR ANCHOR HEIGHT)
• Heavy bag must be hung from a secure anchor. Follow instructions below.
• DO NOT hang body from bag.
• DO NOT kick bag with shoes. Bare feet, socks or specialized kickboxing shoes must be
worn for kicking.
• Wear suitable clothing when working out.
• Be sure to consult a healthcare professional before beginning this or any type of exercise
program.
STEP 1A STEP 2A
Thank you for purchasing the TORQUE 100 LB HEAVY BAG. The Torque Team is happy to assist you with
product or program questions. Reach us by email at contact@torquetness.com or by phone at 763-754-
7533. For other training tools and equipment, visit www.torquetness.com
The straps are thicker on one end due to the
sewing. Insert the narrow end of the rst strap
through a D-Ring.
Push the thicker end of the strap through the
opening of the thin end.
Measure the height of the anchor point that the bag attaches to. This is the hole that the carabiner (included
with bag) attaches to. Use method A for all heights at 84 in (213 cm) and above. Use B for lower anchor
points.

Post your experience with
#TorqueFitness and connect with
the Torque network.
STEP 3A
STEP 5
STEP 4A
STEP 6
Pull the thin part of the strap tight, ensuring that
the thick end of the strap is centered on top.
Repeat steps 1-3 for remaining three straps.
Thick End
Turn snap-hook so that it faces strap on opposite
side of bag and attach second strap.
Hang snap-hook from support member so that
large end is down. Attach rst strap to snap-hook.
Turn snap-hook back so that it faces the third strap
and attach to snap-hook. Turn snap-hook 180
degrees so that it faces nal strap and attach to
snap-hook. Attach snap-hook to anchor point.

Post your experience with
#TorqueFitness and connect with
the Torque network.
STEP 1B
STEP 3B
STEP 2B
STEP 4B
Pull the folded strap through two opposing
D-Rings, ensuring that the thick end of the strap is
centered between D-Rings.
Thick End
Turn snap-hook so that the large end is down and
hook both ends of rst strap.
Repeat step 1B for adjacent two D-Rings.
Turn snap-hook and hook both ends of second
strap. Attach snap-hook to anchor point.
SET-UP (B) (Choose method (A) for normal set-up or method (B) for set-up on low anchor point.)
(Method (B) will raise the height of the bag and is recommended for use on the Torque
Fitness X-Create 8 Foot Upright. Use method (A) for attaching to X-Create Bridge Systems.