tropitone Crestwood Round KD Table User manual

MORE INFORMATION
For care and cleaning instructions, refer to the Tropitone® Care,
Maintenance, Safety & Warranty Information guide included with your
furniture and available at www.tropitone.com/warranty.
Additional care information, “How To” videos and assembly
instructions for Tropitone Outdoor Furniture and Basta Sole shade
products are also available at our website.
If you have difficulty understanding any of the instructions and need
assistance while assembling your Crestwood KD Tables, please call
Tropitone’s Customer Service Center at 949-951-2010.
Tropitone Furniture Co., Inc.
5Marconi, Irvine, CA 92618
949 951 2010 phone
www.tropitone.com Part # R9T00063
Revised: 01.20.2023
2023 Tropitone Furniture Co., Inc.
Crestwood Round KD Tables
41
Assembly Instructions
Congratulations on the purchase of your Tropitone®
Crestwood KD Table.Read through all steps before
fastening components together.
CAUTION: Do not try to lift or flip furniture components
with only one person. Components may be heavy and
awkward to handle, and may result in injury to persons or
damage to property if not lifted properly. Once the Table
Top has been installed, use 2 persons to turn the
assembled table over to an upright position.
Tools Required
Safety Glasses
7/16” Hex Head Socket Wrench
Parts List
(4) Legs
(1) Table Top
(1) Center Brace
(4)¼-20 X1” Hex Bolt
(4) ¼-20 X 1-1/4” Hex
(8) ¼” Lock Washers
(8) ¼” Flat Washers
Check that all items listed in the Parts List are in your carton.
Assembled furniture
is heavy. Assemble
at place of use.
B
A

Prepare a smooth, non-scratch work surface (shipping carton, a
tarp or pool towels can be used).
Table Top Assembly
Place Table Top upside down on the prepared work surface.
Mounting Pads should be facing upwards.
With the Cross Brace attached, place the four legs onto the four
corner mounting posts of the Table Top.
Loosely attach each leg with One (A) bolt and two washers. Do
not fully tighten until all four legs are attached.
Fully tighten all bolts.
Check 8 bolts to ensure that all are fully tightened.
2 3
Base Assembly
Loosely attach each leg with one (B) bolt, one flat washer, and one
lock washer. Do not fully tighten at this point.
Repeat process until all four legs are loosely attached to the Cross
Brace
B B
B
B
A
A
A
A