tropitone Stoneworks Palazzo Pedestal Table User manual

Step 6 Umbrella Installation (Optional)
Remove the Umbrella Hole Cap from the center of the Table
Top. Un-screw the Umbella Security Screw.
Step 7 Umbrella Installation (Optional)
With two persons, insert the umbrella pole through the
umbrella hole in the Table Top and gently slide down until
the pole seats at the bottom. Tighten the Umbrella Security
Screw until snug and the umbrella is difficult to lift or rotate.
If you have difficulty understanding any of the instructions
and need assistance while assembling the table together,
please call Tropitone’s Customer Service Center at
949-951-2010.
Tropitone Furniture Co., Inc.
5 Marconi, Irvine, CA 92618
949 951 2010 phone
www.tropitone.com
Part # R9T00116
Revised: 09.26.07
Stoneworks™ Palazzo
Pedestal Table
Top & Base Assembly Instructions
Read through all steps before assembling the table together.
CAUTION: Do not try to lift or flip furniture
components with only one person. Components may
be heavy and awkward to handle, and may result in
injury to persons or damage to property if not lifted
properly.
Tools Required
5/16” Wrench or Flat Head Screwdriver
Phillips Screwdriver
Safety Glasses
Parts List
Pedestal Base Assembly (approx. 86 lbs.)
Table Top (approx. 120 lbs.)
(4) “L” Brackets
(12) #12 x 1” Self Tapping Hex Head Screws
Check that all items listed in the Parts List are in your
carton.

Table Top & Base Assembly
Step 1
Assembled table is heavy; put it together at place of use.
With two persons, lay the Pedestal Base Assembly on its
side on the carton or on a tarp or pool towels. Loosen the ten
(10) glides approximately the same number of threads.
Step 2
With two persons, tilt the
Pedestal Base upright. Position
the Umbrella Security Screw for
appearance and ease of
access. Adjust glides to level
the base and prevent wobbling.
Step 3
Attach the four (4) “L” Brackets
by installing eight (8) Self
Tapping Screws into the pre-
drilled pilot holes on the base.
Don’t fully tighten at this time.
Step 4
With two persons, lift the Table Top onto the Pedestal Base
and align the Table Top. The raised circular area on the
underside of the top must be aligned with the base.
Step 5
Attach the Table Top by installing the four (4) remaining
screws through the “L” Brackets (4 places). The second
person may need to press down on the top. Fully tighten all
three screws at each bracket (12 places).