tropitone Mia Woven Lounger 361050 User manual

1
Mia Woven Collection
Component Assembly Instructions
361050 Lounger 361052 Ottoman
Congratulations on your purchase of the Mia Woven Collection.
Read through all steps before fastening components together.
WARNING! Do not try to lift or flip furniture components
with only one person. Components may be heavy and
awkward to handle, and may result in injury to persons or
damage to property if not lifted properly.
CAUTION: DO NOT LIFT FURNITURE BY OR REMOVE THE
BLACK STRAPS. THESE ARE USED FOR CUSHION
CONNECTION!
Shown without cushions installed.
Parts List
(2) Connecting Brackets
Tools Required
None
Assembled furniture is
large & ver
y
heav
y
. Put
together at place of use.
2
Confirm all Glides are screwed all the way in.
Components are assembled in upright position by reaching
under frame members.
Assembled furniture is large and heavy. Put together at
place of use.
Use the shipping carton, pool towels or a tarp to prepare a
clean work surface.
Step 1
Unscrew (2) Glides from
Lounger left and right front
corners (as seated).
Unscrew (2) Glides from
Ottoman left and right rear
corners (at straight edge).
Place Bracket onto Glides.
Connect a Glide to Lounger.
Align at a slight angle. Don’t
fully tighten Glide at this time.
Repeat for other side.
Step 2
Lift the Ottoman to the
Lounger to nest the Ottoman
against the Lounger between
the arms. The Ottoman will
be resting on its Glide.
Connect the Glide to the
Ottoman and fully tighten.
Fully tighten Glide on the
Lounger.
Repeat for the other side.

3
Step 3
CAUTION: DO NOT REMOVE OR LIFT FURNITURE BY THE
BLACK STRAPS USED FOR CUSHION CONNECTION!
Place the seat cushion with
zipper to the back onto the
Lounger. Wrap the seat
cushion straps around the (2)
black straps and close the
Velcro®.
Place the seat cushion with
zipper to the back onto the
Ottoman. Wrap the seat
cushion straps around the (3)
black straps and close the
Velcro®.
If necessary, adjust the Glides to level the furniture.
Add the optional throw pillows, then enjoy your furniture!
Alternative Ottoman Configuration
Unscrew (2) glides from each
Ottoman left and right
corners (at straight edge).
Place Brackets onto Glides.
Connect two Glides to the 1st
Ottoman so connector sticks
out as shown in Step 1. Don’t
fully tighten Glides.
Lift the 2nd Ottoman to 1st
Ottoman so 2nd Ottoman is
resting on its Glides.
Push the two Ottomans together firmly and fully tighten the Glides
onto the 2nd Ottoman. Caution: don’t cross-thread the Glides;
keep them straight when engaging threads.
Fully tighten the Glides on the 1st Ottoman.
Install cushions as described in Step 3 above. If necessary, adjust
the Glides to level the furniture.
4
For additional assembly and product care instructions such as
fabric and woven care, see www.tropitone.com and select Product
Care and select:
Saftety, Care, Maintenance and Warranty Information (PDF)
If you have difficulty understanding any of the instructions and
need assistance while fastening your components together,
please call Tropitone’s Customer Service Center at 949-951-2010.
Tropitone Furniture Co., Inc.
5 Marconi, Irvine, CA 92618
949 951 2010 phone
www.tropitone.com
Part # R9TMIAWOV
Revised: 041410
©2010 Tropitone Furniture Co., Inc.