Ballard Designs Trucco SF071 User manual

Prevent accidentally discarding small parts or
hardware. Retain all carton contents until assembly
and installation are complete.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
UPDATED: 9-17-2020 Page 1 of 4
PRODUCT NAME: Trucco Sideboard
ITEM NUMBER: SF071
ASSEMBLED DIMENSIONS : 34”H x 42.5”W x 16”D
MADE IN INDIA
Customer Service: 800-367-2810
Online: www.ballarddesigns.com

Page 2 of 4
Ltr.
A1
B
Qty. Hardware Included
Ltr.
1
2
Qty. Components
C
REQUIRED TOOLS:
Phillips Screwdriver, Pencil,
Drill with a Drill Bit
-Two person assembly suggested.
Remove all parts, hardware and
protective packaging from carton
and carefully arrange on a clean,
level, padded surface.
Wall Anchoring
Anti-tip Kit
See Page 3
Sideboard (B)
Adjustable* Shelves (C)
(Inside Sideboard)
* To adjust: Lift up and off pre-installed shelf supports. Place in new
location and lay onto supports.
LEVELERS: Sideboard is equipped with Rotary Levelers under each Leg. If necessary, Sideboard
may be adjusted by carefully lifting applicable corner and turning Leveler clockwise/counterclockwise.
Serious or fatal crushing injuries can occur from a furniture tip-over
Tip-Over Hazard
Prevent tipping accidents. Anchor your furniture.
WARNING
ANCHORING HARDWARE INCLUDED
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Assemble in location for intended use.

Page 3 of 4
Customer Service: 800-367-2810
Online: www.ballarddesigns.com
Optimal support is provided when Wall Bracket
is anchored directly into a Wall Stud.
Cleaning and Care
DO NOT use alcohol based products or spray polishers
as finish damage may result.
Periodically dust with a soft, dry cloth.
Toggle Bolts (No Wall Stud)
See Page 4 for Details
Screws
(Wall Stud)
Cable
Wall Bracket
If possible, center Wall Bracket (F) on a Wall Stud in line with pre-installed Bracket on back of Sideboard.
Use Screws (D) to anchor it into Wall Stud. If it is not possible to align with a Wall Stud (open drywall)
use Toggle Bolts (G) to attach Wall Bracket. See Page 5 for installation details.
Once Wall Bracket is secured to wall, attach Cable (E) at each end to join and secure Sideboard to Wall.
Position
Wall Bracket
Vertically on Stud

Page 4 of 4
Toggle Bolts are designed for installation location(s) where no Wall Stud is present.
Please read instructions carefully and completely to insure Furniture is securely anchored
to wall, preventing a dangerous tip-over accident.
TOOLS REQUIRED:
Screwdriver, Pencil,
Drill and Drill Bit
Drywall
Drill Bit
Create Pilot Hole Add Bracket to Bolt. Push in until Toggle opens.
Pull back to engage Toggle with inside Wall surface. Tighten Bolt until Bracket is secured.
12
34
INSTALLING TOGGLE BOLTS
BRACKET
Toggle Bolts (G)
Customer Service: 800-367-2810
Online: www.ballarddesigns.com