U-Line PLAZA H-4337 User manual

PAGE 1 OF 2 1213 IH-4337
πH-4337
plaza bencH
1-800-295-5510
uline.com
PARTS
Side Frame x 2 Brace x 2
Concrete Anchors x 4
Cross Support Rod x 2
Bench Planks x 7 Rounded Edge Bench Planks x 2
1½" Screw x 4 1¼" Screw x 36
Bolts x 4 Washers x 4
TOOLS NEEDED
Drill with Phillips Head Bit Ratchet 7mm
ASSEMBLY
1. Loosely attach cross support rods to side frames
using bolts and washers. (See Figure 1)
Figure 1

PAGE 2 OF 2 1213 IH-4337
ASSEMBLY CONTINUED
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com
2. Place the braces equal distance apart on the cross
support rods. (See Figure 2)
NOTE: It may be helpful to have a second
person assist with this step as braces will NOT
stand up on their own.
3. Beginning with the seat, add the planks. The front
plank on the seat and the top plank on the backrest
have a rounded edge. This edge should face out.
(See Figure 3)
4. Space planks appropriately using the special slots in
the side frames to hold each plank. (See Figure 3)
5. Tighten the bolts in the side frames. (See Step 1)
6. Using a drill with Phillips head bit, attach 1¼" screws
through the pre-drilled holes of the brace into the
planks. (See Figure 4)
NOTE: The planks do NOT come with pre-drilled
holes. Only the braces and frames have
pre-drilled holes.
7. Using a drill with Phillips head bit, attach the 1½"
screws through the pre-drilled holes of the side
frames into the two rounded edge planks. These
planks are located at the top of the backrest and at
the front of the seat. (See Figure 5)
Figure 2
Figure 3
Figure 4
Figure 5
Plank Slot
Pre-drilled Hole