U-Line H-540 User manual

PAGE 1 OF 2 1013 IH-540
πH-540, H-572
INDUSTRIAL STRAPPING
TENSIONER
1-800-295-5510
uline.com
PARTS
TIGHTENING HANDLE
WINDLASS
CUTTER WHEEL
GRIPPER PLATE
BASE HANDLE

PAGE 2 OF 2 1013 IH-540
THREADING TENSIONER
(See Figure 1)
1. Wrap both ends of strapping around product.
2. Squeeze handle and base together.
3. Insert the shorter end of strapping under the gripper
plate and cutter wheel leaving approximately 5" of
strapping off the front end.
4. Release handle and base.
5. Feed the other end through the cutter wheel and up
through the windlass.
6. Pull strapping as tight as possible.
TENSIONING
(See Figure 2)
1. Move tightening handle forward and back to begin
tensioning.
2. Continue back and forth motion until strapping has
reached desired tension.
PLACING THE SEAL
1. Seal should be placed open side down on top of
both ends of strapping.
SEALING
(See Figure 3)
1. Close nose of sealer around seal.
2. Crimp tightly around strapping.
REMOVING EXCESS
1. Squeeze handle and base together to cut strapping.
2. Slide tool off to the right.
MAINTENANCE
Tools do need to be cleaned and maintained
periodically with a steel brush or dry compressed air.
Lubricate all moving parts with light machine oil.
Figure 1
Figure 2
Figure 3
OPERATION
π CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com