Ublox EVK-JODY-W163 User manual

Download the EVK-JODY-W1 documentation
from www.u-blox.com/evk-downloads. Build
and install the Linux drivers and tools for the
JODY-W1 module as per the JODY-W1
System Integration Manual.
1. Connect the two antennas to the SMA
connectors, A0 and A1, on the EVK. If you
do not use the antennas, make sure that the
RF ports are properly terminated to a 50 Ω
load.
2. Select signal voltage for SDIO host interface
(2a or 2b) for Wi-Fi via jumper settings.
3. Use the at cable with blue marking
pointing upwards to connect the SDIO
adapter to the connector on the evaluation
board and connect the adapter to the host
system.
4. The power LED is green.
5. Connect the Micro-USB to the host system for
Bluetooth communication.
Quick Start EVK-JODY-W163
2
1
4
UBX-18071262 - R02
3
5
2a (SDIO 1.8 V) 2b (SDIO 3.3 V)
Copyright © 2019, u-blox AG
Setup

Software
The Linux and Android drivers for PCIe and
SDIO host interfaces and support tools for
testing are distributed by Cypress under
the terms of a Software License Agreement
(SLA). Contact u-blox support for your area
for information about how to obtain the
driver package.
Refer to the JODY-W1 System Integration
Manual for information about how to build
and install the drivers and basic usage
examples.
UBX-18071262 - R02
Interfaces
The EVK-JODY-W163 provides an SDIO
connector for Wi-Fi communication. The
board can be powered through the host
interface.
The SMA connectors are provided on the
board for connecting external Wi-Fi and
Bluetooth antennas.
All control lines, an LTE coexistence interface,
and a digital audio interface for Bluetooth
voice applications are available via pin
headers on the evaluation board.
Refer to the EVK-JODY-W1 User Guide for a
comprehensive description of the evaluation
kit features and functionalities.
More information
For more information regarding
EVK-JODY-W163, contact your nearest u-blox
support: www.u-blox.com/support