FOR YOUR OWN SAFETY
1. Read all instructions before using the fan heater.
2. Only connect the fan heater to a single-phase socket with a main voltage
as specified on the rating plate.
3. This appliance meets the electromagnetic compatibility requirements
specified in BN 55104/95 with regard to interference with radio and TV
sets.
4. Do not leave your home while the appliance is in function: ensure that
the switch is in OFF(0) position and the thermostat is in minimum position.
Always unplug the appliance.
5. Keep combustible material such as furniture, cushions, bedding, paper,
clothes, curtains etc. at least 100cm away from the fan heater.
6. If wall mounted do not fix to combustible material such as wooden,
synthetic or plastic surfaces. Do not hang anything on or in front of the fan
heater.
7. Always unplug the heater when not in use. Dot not pull the cord to
unplug the heater.
8. Keep the air inlet and outlet free from objects: at least 1 m in front and
50 cm behind the heater.
9. Do not install the heater right below a socket.
10. Do not let animals or children touch or play with the fan heater. Pay
attention! The air outlet gets hot during operation (more than 80℃, or 175
F ).
11.WARNING: In order to avoid overheating, do not cover the heater.
12. Do not use this fan heater in the immediate surroundings of a bath, a
shower or a swimming pool.
13. Do not use the fan heater in the rooms with explosive gas or while
using inflammable solvents, varnish or glue.
14. If the power cord is damaged it must be replaced by the manufacturer,
its service agent or similarly qualified persons in order to avoid a hazard.
15.Keep the fan heater clean. Do not allow any objects to enter any
ventilation or exhaust opening as this may cause electric shock, or fire or
damage to the heater.
INSTALLATION
The appliance requires no installation, it should be used solely as a portable
appliance.
Portable appliances are not suitable for use in a bathroom.
OPERATION
- Turn the thermostat knob (right) in a clockwise direction until it reaches the
maximum setting.
- Summer service (ventilation only): turn the knob to setting
- Heating at reduced power: turn the knob (right) to setting
Ⅰ
(1100W).
- Heating at full power: turn the (right) to setting
Ⅱ
(2100W).
- Switching off: turn the knob (left) to setting O.
Thermostat Pilot lamp Switch
REGULATING THE THERMOSTAT
When the room has reached the required temperature turn the right thermostat
knob (where included). In an anti-clockwise direction up to the point where the
appliance switches off and not beyond. The temperature fixed in this way will
be automatically regulated and kept at a constant level by the thermostat.
IMPORTANT SAFETY FEATURES
This heater is equipped with an AUTOMATIC OVERHEAT SAFETY DEVICE
that will turn off the power to the heating element should the internal
temperature of the heater exceed normal levels. If this should happen the
heating element will turn off, but the fan will continue to run to help cool the
heater. Should this condition occur immediately remove any obstructions and
set the heater on a level surface. When the temperature returns to normal levels
power to the heating element will be restored and the heater should function
normally.
