URBAN OUTFITTERS AKINA 81201667 User manual

AKINA HEADBOARD
Assembly Instructions
URBAN OUTFITTERS

TOOLS REQUIRED BUT NOT INCLUDED:
Electronic stud finder, Phillips screwdriver, Drill, Pencil
WARNINGS:
Do not throw away packing materials and carton until after
assembly. Assemble all parts on a clean surface.
This hanging system is meant for dry wall/stud mounting only.
If walls are concrete, brick are plaster, please consult your local
hardware store for assistance. For safety and ease of
mounting, use two people. Professional installation is
recommended.
CARE INSTRUCTION:
Avoid direct exposure to sunlight. Do not place overheat or air
conditioning vents. Adjust levelers so that the furniture sits flat on
uneven floors.
Do not rub blot spills. Clean with a dry white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
PARTS INCLUDED
(A) HANGMAN
x1
  
(D) BUBBLE LEVEL
x1
(B) STUD MOUNTING SCREW
x17
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, In c. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted.
�
(C) PLASTIC ANCHOR
x17
Page 1 of 2

URBAN OUTFITTERS
STEP 1
A) Determine the desired placement on the wall for headboard on the wall.
B) Use a stud finder to locate studs within the desired placement for the headboard and mark their location on the
wall with a pencil. It is recommended screw directly into at least (x1) stud.
C) Insert the included bubble level into the track on the loose hangman, as close to the center of the wall mount
bracket as possible.
D) With help, place the hangman on the wall, centering at least (x1) of the hangman holes on a marked stud location.
Check for level and mark the location of the hangman holes on the wall.
E) Remove the hangman from the wall and pre-drill at the marked hole locations that do not align with a stud. Insert
the plastic anchors into the pre-drilled holes.
F) Place the hangman back on the wall and insert screws through the hangman into the plastic anchors. Tighten with
a phillips head screw driver.
G) Insert the remaining screws into the holes aligned with studs and tighten with a drill.
STEP 2
With help, lift the headboard onto the hangman mounted to the wall to complete assembly.
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 U O, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted.
Page 2 of 2
AKINA HEADBOARD
Assembly Instructions