URBAN OUTFITTERS LINNEA User manual

TOOLS REQUIRED BUT NOT INCLUDED:
Phillips head screw driver
Assembly Instructions
Do not throw away packing materials and carton until after assembly.
Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place over heat or Air conditioning vents.
Adjust levelers so that the furniture sits flat on uneven floors.
Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
PARTS INCLUDED
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 1 of 4
HARDWARE LIST
LINNEA - 6 DRAWER DRESSER
(A) Handle
Quantity: 6pcs
(1)Bolt
M6 x 25mm
Quantity: 12pcs
(2) Allen key
Quantity: 1pc
TIP KIT
(3) Anti-tip kits
Quantity: 2pcs (4) Screw M4 x 15mm
Quantity: 2pcs
(5) Screw
M4 x 25mm
Quantity: 2pcs
(6) Wall blugs
(2 is extra)
Quantity: 4pcs

Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 2 of 4
STEP 1.
2
1
21
LINNEA - 6 DRAWER DRESSER
STEP 2.
Pull the drawers out and locate the hardware inside. Unscrew handles inside drawers with allen key (2).
Align the handles (A) as shown. Insert the bolts (1) from the back and tighten with allen key (2).
A

Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 3 of 4
STEP 3.
LINNEA - 6 DRAWER DRESSER
Wall
35
64
Align the anti tip brackets (3) to the top back of the case. Insert screws (4) and tighten completely. Do not
over-tighten. Contact your local hardware store to purchase the correct anchors for your wall-type. Align the
brackets to the wall and make sure they line up with the brackets on the back of the case. Screw the brackets
to the wall using the correct anchors. Slide the case to the wall. Leaving a little bit of room between the case
and the wall. Feed the Nylon Strap through both brackets and pull tight.

Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent rights.
Any unauthorized reproduction, adaptation, distribution or other infringement will be prosecuted. Page 4 of 4
LINNEA - 6 DRAWER DRESSER
FINISH
1425mm [56 1/8"]
460mm [18 1/8"]
812mm [32"]
200mm
[7 7/8"]