URBAN OUTFITTERS WILLOW TALL 82996737 User manual

WILLOW TALL
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted. Page 1 of 3
TOOLS REQUIRED BUT NOT INCLUDED:
N/A
WARNINGS:
Do not throw away packing materials and carton until after
assembly. Assemble all parts on a clean smooth surface
CARE INSTRUCTIONS:
Avoid direct exposure to sunlight. Do not place overheat or air conditioning
vents. Adjust levelers so that the furniture sits flat on
uneven floors.
Blot spills do not rub, with a clean white cloth.
Do not use harsh chemicals.
Before cleaning any part test a small spot in a hidden area.
You may need to re-tighten all bolts after initial use.
PARTS INCLUDED
(A) Top Panel (B) Leg (C) Shelf
x1 x4 x1
HARDWARE LIST
(D) Hex key
x 1
(E) Bolt
[1/4” x 2-1/6”] x4
(F) Bolt
[1/4” x 5/8”] x12
(G) Spring washer
[1/4”] x16
(H) Flat washer
[1/4”] x16
(I) Half-moon metal block
x4
34.25"
13"13"

WILLOW TALL
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted. Page 2 of 3
STEP 1
With help lay the Parts out onto a clean smooth surface such as carpet or cardboard. Align Legs (B) and Top panel (A) as shown
below. Insert Flat Washer (H), Spring Washer (H) and Bolt (F) as shown. Tighten with supplied Hex Key (F). Do not over-tighten.
STEP 2
Align the Shelf (C) and Leg (B) as shown. Align the Leg (B) to connect the Top panel (A). Insert Flat Washer (H), Spring Washer
(G), and Bolt (F). Tighten with supplied Hex Key (D).

WILLOW TALL
Assembly Instructions
EXCLUSIVE AND CONFIDENTIAL PROPERTY OF URBAN OUTFITTERS, INC.
© 2017 UO, Inc. All rights reserved, including all applicable copyright, design and patent
rights. Any unauthorized reproduction, adaptation, distribution or other infringement will be
prosecuted. Page 3 of 3
STEP 3
Align the Shelf to the Legs and press firmly into place. Insert Half-moon metal block (I), Flat Washer (H), Spring Washer (G) and
Bolt (E). Tighten with supplied Hex Key (D). Once complete carefully stand the Table upright without leaning it on the legs as this
can damage them.