V-tech Pop-a-balls Pop & Count Ball Pit User manual

Instruction Manual
Pop & Count Ball Pit
TM
TM

2
2
INTRODUCTION
Thank you for purchasing the Pop-a-BallsTM Pop & Count Ball PitTM!
Playtime gets a boost with thirty balls and over three feet of space to
play in. This interactive, animal-themed ball pit engages little ones in
play and learning. Count, pop, slide and sing!
Light-Up
Buttons
On/Off/Mode
Selector
Buttery
Leaf Ramps
Bird
Collapsible Ball Pit
Electronic Tree
Activity Panel
Basket
30 Balls
Activity Tree
Base
Ball Flipper

3
3
INCLUDED IN THE PACKAGE
• Pop-a-Balls™ Pop & Count Ball Pit™
• One activity tree base • One electronic tree activity panel
•One basket • One attachment clip
• One collapsible ball pit • One sheet of labels
• 30 balls
• Quick Start Guide

4
4
WARNING
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy, and should be discarded for your child’s safety.
NOTE
Please save this Instruction Manual as it contains important information.
ATTENTION
Pour la sécurité de votre enfant, débarrassez vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes, cordons et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de sauvegarder ce manuel d’utilisation car il comporte
des informations importantes.
Please stick the labels to the product securely as indicated below:

5
5
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Locate the battery cover on the back
of the electronic tree activity panel.
Use a screwdriver to loosen the
screw and open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AAA batteries following
the diagram inside the battery box.
Replace the battery cover and tighten
the screw to secure.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Dispose of batteries safely. Do not dispose of batteries in re.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.

6
6
RECHARGEABLE BATTERIES
• Remove rechargeable batteries from the toy before charging.
• Rechargeable batteries are only to be charged under adult
supervision.
• Do not charge non-rechargeable batteries.
IMPORTANT : INFORMATIONS CONCERNANT LES PILES
• Mettre en place les piles ou les accumulateurs en respectant les
polarités + et –.
• Ne pas mélanger des piles ou des accumulateurs neufs avec
des usagés.
• Ne pas mélanger différents types de piles : alcalines, zinc-
carbone et rechargeables.
• Seules des piles du type recommandé doivent être utilisées.
• Ne pas mettre les bornes d’une pile ou d’un accumulateur en
court-circuit (en reliant directement le + et le –).
• Retirer les piles ou les accumulateurs en cas de non-utilisation
prolongée.
• Enlever les piles ou les accumulateurs usagés du jouet.
• Ne les jeter ni au feu ni dans la nature.
PILES RECHARGEABLES
• Enlever, lorsque c’est possible, les accumulateurs du jouet pour
les recharger.
• Les accumulateurs ne doivent être chargés que sous la
surveillance d’un adulte.
• Ne pas tenter de recharger des piles non rechargeables.

7
7
ASSEMBLY INSTRUCTIONS
With the Pop-a-BallsTM Pop & Count Ball PitTM, safety comes rst. To
ensure your child’s safety, adult assembly is required.
1. Attach the Basket to the Electronic Tree
Activity Panel. You will hear the pieces
snap together to indicate the parts are
connected. Once the parts have been
connected, they cannot be separated.
2. Insert the Electronic Tree Activity Panel to
the Activity Tree Base. You will hear the
pieces snap together to indicate the parts
are connected. Once the parts have been
connected, they cannot be separated.
3. Place the Activity Tree Base in the ball pit.
Hook the two straps on either side of the
Activity Panel Base.
4. Slide the Electronic Tree Activity Panel
against the fabric wall. Locate the two
slots on the back of the Electronic Tree
Activity Panel and fasten it to the fabric
wall using the Attachment Clip. You will
hear the Attachment Clip snap into place
when inserted correctly.
5. To fold up the collapsible ball pit for
storage, remove the Activity Tree and
put the Balls in the middle of the ball
pit. Fold the panel opposite the tallest
panel over the Balls then fold in the two
sides. Tie the two Ties together.

8
8
PRODUCT FEATURES
1. On/Off/Mode Selector
To turn the unit On, slide the On/Off/
Mode Selector to the Explore mode
or the Music mode position. You
will hear a song, phrase and sounds.
To turn the unit Off, slide the On/Off/
Mode Selector to the Off position.
2. Automatic Shut-Off
To preserve battery life, the Pop-
a-Balls™Pop & Count Ball Pit™
will automatically shut off after
approximately 50 seconds without
input. The unit can be turned on again
by sliding the On/Off/Mode Selector,
pressing the Light-Up Buttons,
twisting the Buttery or sliding the Bird.
NOTE
If the unit powers down or the light fades out during play, please install
a new set of batteries.

9
9
ACTIVITIES
1. Basket
Drop the Balls into the Basket to hear
the balls counted up to ten in Explore
mode or hear fun sounds in Music
mode. The lights will flash with the
sounds.
2. Light-Up Buttons
Press the three Light-Up Buttons to
learn about animals and colors and
follow simple instructions in Explore
mode. In Music mode, you will hear
melodies and sing along songs and
follow simple instructions. The lights
will ash with the sounds.
3. Bird
Slide the Bird to hear playful sounds,
phrases and music. If there is a ball on
the Leaf Ramp, slide the Bird to see
the ball slide down the Leaf Ramp and
through the basket. The lights will ash
with the sounds.
4. Buttery
Twist the Butterfly to hear playful
sounds and phrases in Explore mode.
In Music mode you will hear short tunes
and melodies. If there is a ball on the
Leaf Ramp, twist the Buttery to see
the ball slide down the Leaf Ramp and
through the basket. The lights will ash
with the sounds.
NOTE
The infrared light sensors in the basket are sensitive to sunlight.
The sensors may not perform properly in brightly lit, sunny rooms or
under direct sunlight.

10
10
MELODY LIST
1. Aiken Drum
2. Alphabet Song
3. A-Tisket, A-Tasket
4. The Bear Went Over the Mountain
5. Bicycle Built for Two
6. Bingo
7. The Entertainer
8. Girls and Boys Come Out to Play
9. Glow Worm
10. Humpty Dumpty
11. London Bridge
12. Mulberry Bush
13. Oats, Peas, Beans, and Barley Grow
14. Old MacDonald Had a Farm
15. One Man Went to Mow a Meadow
16. Pease Porridge Hot
17. Row, Row, Row Your Boat
18. Skip to My Lou
19. Teddy Bears’ Picnic
20. Toyland
SONG LYRICS
Song 1
Balls are popping up and down,
Bouncing and rolling around.
Red and blue, and yellow and green.
Poppity, poppity pop!

11
11
Song 2
Drop a blue ball in.
Pop and red ball up.
Launch a green ball in the air,
The balls all bounce around.
Song 3
Join the fun and count with me.
One, two, three.
Four, ve, six.
Seven, eight, nine, ten!
Song 4
Turtle, turtle, where are you?
Are you hiding in your shell?
Peek-a-boo, we see you!
Song 5
Elephant’s trunk is oh so long,
Oh so long, oh so long.
Elephant’s like to wiggle their ears,
All day long!
Song 6
Lion is so fast and strong,
Running through the jungle, bounding along.
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct
heat sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.

12
12
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-521-2010 in the U.S., 1-877-352-8697 in
Canada, or by going to our website vtechkids.com and lling out
our Contact Us form located under the Customer Support link.
Creating and developing VTech products is accompanied by a
responsibility that we take very seriously. We make every effort to
ensure the accuracy of the information, which forms the value of
our products. However, errors sometimes can occur. It is important
for you to know that we stand behind our products and encourage
you to contact us with any problems and/or suggestions you might
have. A service representative will be happy to help you.
CAUTION
changes or modications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
Note
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment

13
13
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC
RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO
CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT
MAY CAUSE UNDESIRED OPERATION.
Supplier’s Declaration of Conformity
47 CFR § 2.1077 Compliance Information
Trade Name: VTech®
Model: 5336
Product Name: Pop-a-BallsTM Pop & Count Ball PitTM
Responsible Party: VTech Electronics North America, L.L.C.
Address: 1156 W. Shure Drive, Suite 200
Arlington Heights, IL 60004
Website: vtechkids.com

Visit our website for more
information about our products,
downloads, resources and more.
vtechkids.com
vtechkids.ca
TM & © 2021 VTech Holdings Limited.
All rights reserved.
IM-533600-000
Version:1
Read our complete warranty policy online at
vtechkids.com/warranty
vtechkids.ca/warranty