
PROTECTIONS
CAUTIONS
ENGLISH
1. Install & Replace the Pod
Pull out the pod from the battery and install the
new one.
*If it’s the rst time using the device, please tear
off the sticker of the pre-installed pod.
2. Fill the E-liquid(Refer to FIGURE 1)
Snap off the mouthpiece then squeeze the e-liquid
through lling slot. After lling, put the mouthpiece
back and make sure it’s shut rmly.
*If it’s the rst time lling the e-liquid, please wait
5 minutes for the coil to prime.
3. Adjust Airow(Refer to FIGURE 2)
There is an airow control toggle on the side of the
battery. Adjust the toggle according to your vaping
habits for different airow effects.
4. Start Vaping
The device is draw-activated. Inhale through the
mouthpiece and exhale to start vaping.
5. Check the Battery Level
The LED indicator will stay in green/blue/red color to
show the battery level after vaping or inserting the
pod.
Low Resistance/Short-circuit/High Temperature: The
red indicator will ash 5 times and the device will
stop working.
No Load/High Resistance: The current battery level
indicator will ash 5 times and the device will stop
working.
Low Voltage/Over Discharging: The red indicator will
ash 3 times and the device will stop working.
Over Charging: The green indicator will stay on and
the device will stop charging.
Overtimes(8s): The device will stop working and the
LED indicator will ash in green-blue-red.
Battery Level LED Color
70%~100% Green
30%~70% Blue
0~30% Red
6. Charging
Please use the in-box Type-C cable to charge the
device. The LED indicator will stay in green while
fully charged.
1. Do not leave the charging device unattended.
2. Do not drop, throw or abuse your device, which
may cause damage.
3. Please use a standard USB output charger with
proper charging current and voltage range.
4. Keep away from the water or any ammable gas,
liquid .
5. Do not expose the device to direct sunlight, dust,
moisture or mechanical shock.
6. Do not expose the device to extreme temperature.
(Recommended temperature range: -10~60℃
USER INSTRUCTIONS